On Distortion Correcting of Welded Thin Plate Structures (Part II)
نویسندگان
چکیده
منابع مشابه
Welding Distortion of a Thin-Plate Panel Structure
Welding thin-plate panel structures often results in warping of the panels. Several mitigation methods, including preheating and prestressing the plates during assembly, have been investigated and used by some fabricators. This paper studies the distortion mechanisms and the effect of welding sequence on panel distortion. In this study, distortion behaviors, including local plate bending and bu...
متن کاملDistortion of laser welded titanium plates.
The distortion of laser welded titanium plates was assessed for different operating conditions of the laser welding device, and with different welding parameters (in terms of weld point and prewelding). In this study, Nd : YAG laser welding device was used to join the titanium plates. The results showed that distortion increased stepwise after each welding point along the welding zone (one-side...
متن کاملInterpolation of Rainfall Data with Thin Plate Smoothing Splines - Part II: Analysis of Topographic Dependence
Thin plate smoothing splines incorporating varying degrees of topographic dependence were used to interpolate 100 daily rainfall values, with the degree of data smoothing determined by minimizing the generalised cross validation. Analyses were performed on the square roots of the rainfall values. Model calibration was made difficult by short range correlation and the small size of the data set....
متن کاملJunction of a periodic family of elastic rods with a thin plate. Part II
In this second paper, we consider again a set of elastic rods periodically distributed over an elastic plate whose thickness tends here to 0. This work is then devoted to describe the homogenization process for the junction of the rods and a thin plate. We use a technique based on two decompositions of the displacement field in each rod and in the plate. We obtain a priori estimates on each ter...
متن کاملEffect of Process Parameters on Angular Distortion of Gas Tungsten Arc Welded SS 302 and MS Plate
Tungsten Inert Gas (TIG) welding is a widely applied manufacturing process. Angular distortion is a major problem and most pronounced among different types of distortion in the butt welded plates. This angular distortion is mainly due to nonuniform transverse shrinkage along the depth of the plates welded. Restriction of this distortion by restraint may lead to higher residual stresses. However...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1951
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.20.202