On High-Strength Concrete Reinforcing Steel Bars
نویسندگان
چکیده
منابع مشابه
Bond of High Strength Concrete with High Strength Reinforcing Steel
This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...
متن کاملCorrosion of Reinforcing Bars in Concrete
The causes and mechanisms of corrosion of reinforcing bars in concrete are described in terms of the practical issues as well as the electrochemistry. The parameters affecting corrosion are (i) the ingress of aggressive species, such as chlorides, which break down the protective film on the reinforcing bar and (ii) the amount of those species necessary to do so. The former is largely controlled...
متن کاملSplice Strength of High Relative Rib Area Reinforcing Bars
The reinforcing bar deformation patterns currently used in the U.S. were established over 45 years ago. In the interim, material properties and design procedures have changed, resulting in more congested reinforcement, the use of higher strength materials, and the application of coatings to provide corrosion protection. Based on an improved understanding of the interaction between reinforcing s...
متن کاملTorsion Behavior of Steel Fibered High Strength Self Compacting Concrete Beams Reinforced by GFRB Bars
This paper investigates experimentally and analytically the torsion behavior of steel fibered high strength self compacting concrete beams reinforced by GFRP bars. Steel fibered high strength self compacting concrete (SFHSSCC) and GFRP bars became in the recent decades a very important materials in the structural engineering field. The use of GFRP bars to replace steel bars has emerged as one o...
متن کامل08323 - Cathodic Behavior of Stainless Steel 316LN Reinforcing Bars In Simulated Concrete Pore Solutions
The high corrosion resistance of stainless steel (SS) reinforcing bars is widely recognized. However, little information is available on how much cathodic current a passive SS rebar assembly could produce to support a local anode as corrosion eventually starts. The ability of SS to perform as a cathode would have a direct impact on the corrosion rate of the anodic region. To address this issue,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1961
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.47.5_745