On the Personal Sampler
نویسندگان
چکیده
منابع مشابه
A Personal, Thermophoretic Sampler for Airborne Nanoparticles
HEPA Filter Critical Flow Orifice A personal, thermophoretic particle sampler was designed to collect airborne nanoparticles in the breathing zone of exposed workers. The thermal precipitator captures aerosol by creating a 1000 ̊C/cm temperature gradient between two aluminum plates (0.1 cm separation distance) using a resistive heater, a thermoelectric cooler, a temperature controller, and two t...
متن کاملDetermining the spatial variability of personal sampler inlet locations.
This article examines the spatial variability of dust concentrations within a coal miner's breathing zone and the impact of sampling location at the cap lamp, nose, and lapel. Tests were conducted in the National Institute for Safety and Health Pittsburgh Research Laboratory full-scale, continuous miner gallery using three prototype personal dust monitors (PDM). The dust masses detected by the ...
متن کاملLaboratory evaluation of the CIP 10 personal dust sampler.
The "capteur individuel de poussiere" CIP 10 personal dust sampler--developed by the Centre d'Etudes et Recherches de Charbonnages de France (CERCHAR) research organization--is a small, quiet, lightweight unit which samples at a flow rate of 10 L/min. It is a three-stage sampler, using two stages to remove nonrespirable dust particles and one stage to collect the respirable fraction. Airflow th...
متن کاملDevelopment and evaluation of an ultrasonic personal aerosol sampler
Assessing personal exposure to air pollution has long proven challenging due to technological limitations posed by the samplers themselves. Historically, wearable aerosol monitors have proven to be expensive, noisy, and burdensome. The objective of this work was to develop a new type of wearable monitor, an ultrasonic personal aerosol sampler (UPAS), to overcome many of the technological limita...
متن کاملEvaluation of a personal and microenvironmental aerosol speciation sampler (PMASS).
In this study, an all-aluminum sampler was reconfigured to a lighter weight by using plastic for structural components not contacted by aerosol. Because the sampler body was made of plastic, the aluminum size-selective cyclone inlet was redesigned into a separate, removable unit. The resulting personal and microenvironmental aerosol speciation sampler (PMASS*) is a small, compact sampler design...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sangyo Igaku
سال: 1964
ISSN: 0047-1879,1881-1302
DOI: 10.1539/joh1959.6.3_194_3