On Time Compression Overlap-Add Technique in Linear Frequency Modulation Pulse Compression Radar Systems: Design and Performance Evaluation
نویسندگان
چکیده
منابع مشابه
Classifying Pulse Compression Radar Waveforms Using Time-Frequency Distributions
In this paper the classification of pulse compression radar waveforms using features extracted from the Choi-Williams time-frequency distribution is studied. In addition, a feature based on the symmetry properties of polyphase waveforms is introduced. The pulse compression waveforms examined are the Frank, P1, P2, P3, and P4 codes. The discrimination capability of the features is evaluated usin...
متن کاملExtending the Radar Dynamic Range using Adaptive Pulse Compression
The matched filter in the radar receiver is only adapted to the transmitted signal version and its output will be wasted due to non-matching with the received signal from the environment. The sidelobes amplitude of the matched filter output in pulse compression radars are dependent on the transmitted coded waveforms that extended as much as the length of the code on both sides of the target loc...
متن کاملPerformance Evaluation of Barker Codes using New Pulse Compression Technique
Pulse compression is used to achieve large radiated energy but simultaneously a short pulse for range resolution. Range resolution is an ability of the receiver to detect nearby targets. Pulse compression can also detect small target signals out of clutter. The matched filter output consists of unwanted but unavoidable side lobes however the reduction of this side lobe strength is the active re...
متن کاملChapter 10 Pulse Compression Radar
10.1 INTRODUCTION Pulse compression involves the transmission of a long coded pulse and the processing of the received echo to obtain a relatively narrow pulse. The increased detection capability of a long-pulse radar system is achieved while retaining the range resolution capability of a narrow-pulse system. Several advantages are obtained. Transmission of long pulses permits a more efficient ...
متن کاملRadio Frequency Pulse Compression*
High gradients require high peak powers. One possible way to generate high peak powers is to generate a relatively long pulse at a relatively low power and compress it into a shorter pulse with higher peak power. It is possible to compress before DC to RF conversion as is done for the relativistic klystron or after DC to RF conversion as is done with SLED. In this note only radio frequency puls...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Access
سال: 2017
ISSN: 2169-3536
DOI: 10.1109/access.2017.2771799