ON WELD-ON CUTTING TOOL.
نویسندگان
چکیده
منابع مشابه
The Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملThe Influence of Specimens Cutting Direction on the Crack Resistance of Surface Weld Metal
It is well known that the mechanical properties of materials depend of the rolling direction, which means that the direction of specimen cutting affect the obtained values. This feature also exists in the welded joint, where the anisotropy is caused by direction of the deposit welded layers. One high-carbon steel is surface welded by flux-cored wire and specimens were cut in order to determine ...
متن کاملEffects of Tool Setting on Tool Cutting Angle on Turning Operation
Accuracy of machined component is one of the most critical considerations for any manufacturer. Many key factors like cutting tool and its setting angle, machining conditions, resolution of the machine tool and the type of work place etc., play an important role. However, once these are decided upon, the consistent performance of the machine tool depends upon its ability to accurately position ...
متن کاملCutting Tool Geometry Suggestions Based on a Fuzzy Logic Model
This work is about a fuzzy logic model in order to suggest an initial cutting tool geometry for each work-tool material combination. The Takagi-Sugeno-Kang model was used to design the fuzzy system that was trained with suggested empirical cutting tool geometry values. The system inputs are the specific cutting energy of the work material and the ratio of the quadratic bending strength over mod...
متن کاملInfluence of the Tool Edge Geometry on Specific Cutting Energy at High- Speed Cutting
This paper presents specific cutting energy measurements as a function of the cutting speed and tool cutting edge geometry. The experimental work was carried out on a vertical CNC machining center with 7,500 rpm spindle rotation and 7.5 kW power. Hardened steels ASTM H13 (50 HRC) were machined at conventional cutting speed and high-speed cutting (HSC). TiN coated carbides with seven different g...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1940
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.26.4_288