Onset Criterion for Flash Sintering
نویسندگان
چکیده
منابع مشابه
Ultrafast-Contactless Flash Sintering using Plasma Electrodes
This paper presents a novel derivative of flash sintering, in which contactless flash sintering (CFS) is achieved using plasma electrodes. In this setup, electrical contact with the sample to be sintered is made by two arc plasma electrodes, one on either side, allowing current to pass through the sample. This opens up the possibility of continuous throughput flash sintering. Preheating, a usua...
متن کامل8YSZ sintering by flash sintering method and evaluation of process parameters
Flash sintering as a new sintering method for sintering of ceramic materials has been studied and effect of various parameter such as flash current density, time of flash and contact paste on properties of flash sintered 8YSZ samples has been investigated. Results showed it is possible to achieve high density in shorter time and lower temperature than conventional sintering methods. Samples cou...
متن کاملStudy on appropriate and modified conditions for flash sintering process by simulation modeling
Flash sintering is one of the newest techniques for sintering ceramics to near full density. It occurs in an appropriate combination of temperature and electric field. Temperature measurement is one of the most serious challenges in this process. In the present study, we tried to model a flash sintering process of 8YSZ and 3YSZ with finite element method to make an assessment for temperature di...
متن کاملOn the Mechanism of Microwave Flash Sintering of Ceramics
The results of a study of ultra-rapid (flash) sintering of oxide ceramic materials under microwave heating with high absorbed power per unit volume of material (10-500 W/cm³) are presented. Ceramic samples of various compositions-Al₂O₃; Y₂O₃; MgAl₂O₄; and Yb(LaO)₂O₃-were sintered using a 24 GHz gyrotron system to a density above 0.98-0.99 of the theoretical value in 0.5-5 min without isothermal...
متن کاملProbing the densification mechanisms during flash sintering of ZnO
Using ZnO as a model system, the densification mechanisms of flash sintering are investigated. Controlled experiments via limiting the maximum current or the effective ramp rate suggest that both the maximum specimen temperature and the high heating rate (on the order of 200 C/s) are essential for the rapid densification during the flash sintering. Moreover, benchmarking rapid thermal annealing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the American Ceramic Society
سال: 2015
ISSN: 0002-7820,1551-2916
DOI: 10.1111/jace.13866