Optical Fiber Fabrication Using Novel Gas-Phase Deposition Technique
نویسندگان
چکیده
منابع مشابه
Fabrication of Gelatin Scaffolds Using Thermally Induced Phase Separation Technique
Gelatin is considered as a partially degraded product of collagen and it is a biodegradable polymer which can be used to produce scaffolds for tissue engineering. Three-dimensional, porous gelatin scaffolds were fabricated by thermally induced phase separation and freeze-drying method. Their porous structure and pore size were characterized by scanning electron microscopy. Scaffolds with differ...
متن کاملNovel carbon nanotube network deposition technique for electronic device fabrication
Marina Y. Zavodchikova*,1, Albert G. Nasibulin1, Tero Kulmala2, Kestutis Grigoras2, Anton S. Anisimov1, Sami Franssila2, Vladimir Ermolov3, and Esko I. Kauppinen1 1 NanoMaterials Group, Laboratory of Physics and Center for New Materials, Helsinki University of Technology, Espoo, Finland 2 Microfabrication Group, Micro and Nanosciences Laboratory, Helsinki University of Technology, Espoo, Finlan...
متن کاملAn Optical Fiber Displacement Sensor Using RF Interrogation Technique
We propose a novel non-contact optical fiber displacement sensor. It uses a radio frequency (RF) interrogation technique which is based on bidirectional modulation of a Mach-Zehnder electro-optical modulator (MZ-EOM). The displacement is measured from the free spectral range (FSR) which is determined by the dip frequencies of the modulated MZ-EOM transfer function. In experiments, the proposed ...
متن کاملTwo Means of Compensating Fiber Nonlinearity Using Optical Phase Conjugation
The growing demand of higher capacity over longer transmission distances has seen fiber nonlinearity as a major limiting factor in modern optical transmission systems [1, 2]. Among the methods under investigation, nonlinearity compensation using optical phase conjugation (OPC) has emerged as an effective means of suppressing the nonlinear impairments [3, 4, 5]. This paper shall discuss two type...
متن کاملFabrication and Characterization of SPR Based Fiber Optic Probe Using e beam Deposition
A surface plasmon resonance based fiber optic probe has been fabricated using electron beam deposition. The fabricated probe has been characterized using sucrose solution. It has been observed that the resonance wavelength i.e. SPR wavelength increases with increasing concentration of sucrose solution. The experimental results so obtained have been compared with theoretically simulated model re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Lightwave Technology
سال: 2011
ISSN: 0733-8724,1558-2213
DOI: 10.1109/jlt.2011.2109371