OPTICAL WAVEGUIDE DEVICE FOR A MAGNETO-OPTICAL DISK HEAD
نویسندگان
چکیده
منابع مشابه
Design of Arrayed Waveguide Grating based Optical Switch for High Speed Optical Networks
This paper demonstrates the design of an Arrayed Waveguide Gratings (AWG) based optical switch. In the design both physical and network layer analysis is performed. The physical layer power and noise analysis is done to obtain Bit Error Rate (BER). This has been found that at the higher bit rates, BER is not affected with number of buffer modules. Network layer analysis is done to obtain perfor...
متن کاملMagneto-Optical properties of GaP single crystal
The temperature dependence of magneto-optical and magneto-photoconductivity measurements were carried out in the range of (200-330) K. A home made optical cryostat was used for the measurements. The measured room temperature value of the energy gap was found to be 2.211 eV. The temperature coefficient of energy gap was found to be -5.48×10-4 eV/K obtained by the optical absorption method and -4...
متن کاملWaveguide-Plasmon Polaritons Enhance Transverse Magneto-Optical Kerr Effect
Lars E. Kreilkamp, Vladimir I. Belotelov, Jessie Yao Chin,* Stefanie Neutzner, Daniel Dregely, Thomas Wehlus, Ilya A. Akimov, Manfred Bayer, Bernd Stritzker, and Harald Giessen Experimentelle Physik 2, Technische Universität Dortmund, D-44221 Dortmund, Germany Lomonosov Moscow State University, Faculty of Physics, 119991 Moscow, Russia Russian Quantum Centre, 143025 Skolkovo, Moscow Region, Rus...
متن کاملTransparent EuTiO3 films: a possible two-dimensional magneto-optical device
The magneto-optical activity of high quality transparent thin films of insulating EuTiO3 (ETO) deposited on a thin SrTiO3 (STO) substrate, both being non-magnetic materials, are demonstrated to be a versatile tool for light modulation. The operating temperature is close to room temperature and allows for multiple device engineering. By using small magnetic fields birefringence of the samples ca...
متن کاملIntegrated Optical Waveguide Device for Picosecond Pulse Compression
We report on the fabrication and characterization of a new device, named IRIS. It is designed to increase the coherent optical bandwidth of a picosecond pulse train for subsequent pulse compression. The IRIS device consists of a concatenated array of semiconductor optical amplifiers and saturable absorbers. It is realized in the InP/InGaAsP material system for the 1550 nm range. Measurements on...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1998
ISSN: 1880-4004,0285-0192
DOI: 10.3379/jmsjmag.22.s2_163