Optimal lot size and offline inspection policy
نویسندگان
چکیده
منابع مشابه
An Optimal Lot-Sizing and Offline Inspection Policy in the Case of Nonrigid Demand
A batch production process that is initially in the in-control state can fail with constant failure rate to the out-of-control state. The probability that a unit is conforming if produced while the process is in control is constant and higher than the respective constant conformance probability while the process is out of control. When production ends, the units are inspected in the order they ...
متن کاملOn Minimax Optimal Offline Policy Evaluation
This paper studies the off-policy evaluation problem, where one aims to estimate the value of a target policy based on a sample of observations collected by another policy. We first consider the multi-armed bandit case, establish a minimax risk lower bound, and analyze the risk of two standard estimators. It is shown, and verified in simulation, that one is minimax optimal up to a constant, whi...
متن کاملLot sizing with rework and different inspection costs
This paper deals with the single machine multi-product lot scheduling problem in which defective items are produced in any production run of each product. We have adopted the common cycle scheduling policy and assumed that the setup times for production of each product can be non-zero. Further, we have assumed that defective items will be reworked and the inspection costs during the normal prod...
متن کاملOptimal lot size of EPQ model considering imperfect and defective products
The economic production quantity (EPQ) is a commonly used inventory model. An assumption in the EPQ model is that all units produced are perfect. Some researchers have studied the effects after relaxing this assumption on the inventory models. The objective of this paper is to determine the economic production quantity with reduced pricing, rework and reject situations in a single-stage system ...
متن کاملoptimal inspection policy in supplier selection with taguchi loss function
this paper presents a new approach which is based on quality control in order to optimize supplier selection. using inspections, removing the defected materials and considering penalties for low quality materials are the main factors which we have considered in modeling. in this model costs are divided to three parts: 1- costs of purchasing 2- costs of inspection policy 3- costs of quality and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Computers & Mathematics with Applications
سال: 2009
ISSN: 0898-1221
DOI: 10.1016/j.camwa.2009.07.089