OPTIMALISASI AKURASI ANTENA PENJEJAK SATELIT ORBIT RENDAH MENGGUNAKAN MOTOR STEPPER HYBRID 2 FASA (OPTIMIZATION OF LOW EARTH ORBIT TRACKING ANTENNA USING STEPPER MOTOR HYBRID 2-PHASE)
نویسندگان
چکیده
منابع مشابه
Stepper Motor Actuated Microvalve
We present the design, fabrication and characterization of a novel microvalve realized by combining micro and fine machining techniques. The design is for high flow rates at high pressure difference between inlet and outlet, burst pressure of up to 15 bars, there is no power consumption required for the valve to maintain its position during operation in any intermediate state and the process ga...
متن کاملThe L297 Stepper Motor Controller
November 2003 The L297 Stepper Motor Controller is primarily intended for use with an L298N or L293E bridge driver in stepper motor driving applications. It receives control signals from the system’s controller, usually a microcomputer chip, and provides all the necessary drive signals for the power stage. Additionally, it includes two PWM chopper circuits to regulate the current in the motor w...
متن کاملStepper Motors Uncovered ( 1 ) Part 1 : stepper motor fundamentals
36 Elektor Electronics 11/2003 Often a mechanical operation is required in an application to accurately position a load or device. While a conventional DC or AC motor can be used, it is difficult to determine the exact position of the load, motor speed, or how much total motion has been produced, unless external positioning sensors, encoders, servo loops, and controlling devices (brakes or clut...
متن کاملStepper motor and driver selection
Figure 1. Pull-out torque and output power for a 57 mm PM stepper driven by a unipolar L/R-driver and a NJM3770A bipolar constant current driver. Stepper motors are used in many different types of applications this makes it difficult to recommend a general step-by-step design flow chart. The design process is more an iterative process, involving experience, calculation and experimentation. The ...
متن کاملSimulating the Arm Movements of a Stepper Motor Controlled Pick- and-Place Robot Using the Stepper Motor Model
This paper describes the simulation of arm movements of a stepper motor controlled pickand-place robot using the mathematical model of a stepper motor. The model includes: a) a model of the stepper model driver board, b) a model of the hybrid stepper motor and load combination, and c) the interconnection of the two models which is used to simulate the motions of the base, shoulder, elbow, and w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Jurnal Teknologi Dirgantara
سال: 2013
ISSN: 2597-7849,1412-8063
DOI: 10.30536/j.jtd.2013.v11.a1794