Optimization of a fuel cell system using process integration techniques
نویسندگان
چکیده
منابع مشابه
Thermodynamic Investigation and Optimization of a Power Generation System Based Solid Oxide Fuel Cell Using Taguchi Approach
Fuel cells directly convert chemical energy into electrical power using electrochemical reactions. Solid oxide fuel cell (SOFC) is one of the high-temperature fuel cells that propose a promising future from the standpoint of power generation. In this study, optimization of an SOFC system is performed using Taguchi approach after verification of the model in compare with experimental results. Cu...
متن کاملIntegration of a Vanadium Redox Flow Battery with a Proton Exchange Membrane Fuel Cell as an Energy Storage System
The proton exchange membrane (PEM) fuel cell is a green energy producer which converts chemical energy to electricity in high yield. Alternatively, the vanadium redox flow battery (VRB) is one of the best rechargeable batteries because of its capability to average loads and output power sources. These two systems are modeled by Nernst equation and electrochemical rules. An effective energy gene...
متن کاملA Double Pipe Heat Exchanger Design and Optimization for Cooling an Alkaline Fuel Cell System
In the presented research, heat transfer of a mobile electrolyte alkaline fuel cell (AFC) (which the electrolyte has cooling role of system) has been considered. Proper control volumes of system with specific qualification have been chosen. Consequently, heat and mass transfer in control volumes have been assessed. Considerations on them and contributed models lead to approve a double tube heat...
متن کاملEnhancement of Combustion Process in Dual Fuel Engines at Part Loads by using Suitable Techniques
It is a well known fact that, dual fuel engines at part loads, inevitably suffer lower thermal efficiency, higher carbon monoxide and unburned fuel emission. The work in this paper is to investigate combustion characteristics of a dual fuel (diesel-gas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors deve...
متن کاملModeling and Optimization of a Fuel Cell Hybrid System
The purpose of this project was the modeling, optimization and prediction of a hybrid system composed of a fuel cell, a dc-dc converter and a supercapacitor in series. Lab tests were performed for each device to understand their behavior, and then each one was modeled using software (Simulink). The validation of the model was done by comparing its results with measured data; finally the model w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Power Sources
سال: 2003
ISSN: 0378-7753
DOI: 10.1016/s0378-7753(03)00107-1