Optimization of cavitation characteristics of axial flow submersible pump
نویسندگان
چکیده
Abstract In view of the problem that actual performance axial-flow pump is less than theoretical design value, Taking with a designed flow rate 350L/s as research object. The relationship between impeller head and outlet installation angle was studied. influence different blade angles on external characteristics analyzed. Through analysis corresponding to angles, shaft oil verified, basis for structural optimization axial provided.
منابع مشابه
Numerical Simulation of Cavitation in Mixed Flow Pump
The purpose of this study is to investigate the performance and three-dimensional behavior of the flow in a mixed flow pump and the way cavitation phenomenon is affected by different parameters such as fluid temperature, pump speed and flow rate. Computational fluid dynamic software FLUENT 6.3 was utilized to simulate the whole flow field of the pump. RNG k-ε model combined with standard wall f...
متن کاملThe parametric study of an electrical submersible pump rotary gas separator under two-phase flow condition
The performance of the electric submersible pump (ESP) significantly affected by Gas Void Fraction (GVF). Thus, using of a Rotary Gas Separator (RGS) is a suitable solution for this issue. The performance of the RGS is function of different parameters such as geometry of impeller, rotating speed, boundary conditions, media viscosity and GVF. In this study, the influences of GVF, viscosity, ...
متن کاملThe parametric study of an electrical submersible pump rotary gas separator under two-phase flow condition
The performance of the electric submersible pump (ESP) significantly affected by Gas Void Fraction (GVF). Thus, using of a Rotary Gas Separator (RGS) is a suitable solution for this issue. The performance of the RGS is function of different parameters such as geometry of impeller, rotating speed, boundary conditions, media viscosity and GVF. In this study, the influences of GVF, viscosity, and ...
متن کاملMovement of Location of Tip Vortex Cavitation along Blade Edge due to Reduction of Flow Rate in an Axial Pump
Tip vortex cavitation is one of well known patterns of cavitation phenomenon which occurs in axial pumps. This pattern of cavitation occurs due to pressure difference between the pressure and suction sides of blades of an axial pump. Since the pressure in the pressure side of the blade is higher than the pressure in its suction side, thus a very small portion of liquid flow flows back from pres...
متن کاملNumerical Simulation of Cavitation Inception on Radial Flow Pump
Pump cavitation is the formation and subsequent collapse or implosion of vapor bubbles in a pump. It occurs when the absolute pressure on the liquid falls below the liquid’s vapor pressure. This paper describes the validation of cavitation inception on a radial flow pump which develops 21m of head at 26lps of discharge at its best efficiency point (BEP) of discharge while operating at a speed o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of physics
سال: 2022
ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']
DOI: https://doi.org/10.1088/1742-6596/2365/1/012006