Optimization of machining parameters of WEDM for Nimonic-75 alloy using principal component analysis integrated with Taguchi method
نویسندگان
چکیده
منابع مشابه
Optimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method
Wire electrical discharge machining (WEDM) is extensively used in machining of conductive materials when precision is of prime importance. Rough cutting operation in WEDM is treated as a challenging one because improvement of more than one machining performance measures viz. metal removal rate (MRR), surface finish (SF) and cutting width (kerf) are sought to obtain a precision work. Using Taguc...
متن کاملOptimization of WEDM Process Parameters on Titanium Alloy Using Taguchi Method
This paper describes an optimum cutting parameters for Titanium Grade5 (Ti-6Al-4V) using Wire-cut Electrical Machining Process (WEDM). The response of Volume Material Removal Rate (MRR) and Surface Roughness (Ra) are considered for improving the machining efficiency. A brass wire of 0.25mm diameter was applied as tool electrode to cut the specimen. The Experimentation has been done by using Tag...
متن کاملOptimization of Process Parameters of Wire Electrical Discharge Machining Using Fuzzy logic Integrated with Taguchi Method
In this paper, fuzzy logic integrated with the Taguchi method is used to optimize Wire Electro Discharge Machining (WEDM) process with multiple quality characteristics. Rough machining with EDM gives poor surface finish and has micro cracks and pores. Finish machining gives better surface finish but with very poor machining speed (MRR). Spark gap width is one of the important performance measur...
متن کاملMulti-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملParametric Optimization of Wedm Using Grey Relational Analysis with Taguchi Method
Wire EDM is one of the latest advanced micro-machining techniques, where a thin wire (Ǿ= 0.25 mm) of tool electrode is fed on the work piece which gradually shears off the material during the machining process. This micro-machining process may help overcome the limitations and restriction faced during conventional mechanical machining process. This paper is based on wire-EDM machining of a part...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of King Saud University - Engineering Sciences
سال: 2018
ISSN: 1018-3639
DOI: 10.1016/j.jksues.2018.04.001