OPTIMIZATION OF ORTHOTROPIC FIBER-GLASS TRAVERSE-RIBBED SHELLS
نویسندگان
چکیده
منابع مشابه
Intracanal Retention of Glass Fiber Posts
Objective: Fiber-reinforced composite (FRC) posts have recently become more popular for restoring endodontically treated teeth because of providing esthetics, better stress distribution and lower risk of root fracture. Resistance against tensile forces dislodging the post from the root canal is a prerequisite for these posts. This study aimed to evaluate the tensile retention (strength) of in...
متن کاملMulti-objective Optimization of Hybrid Carbon/Glass Fiber Reinforced Epoxy Composite Automotive Drive Shaft
In design and fabricate drive shafts with high value of fundamental natural frequency that represented high value of critical speed; using composite materials instead of typical metallic materials could provide longer length shafts with lighter weight. In this paper, multi-objective optimization (MOP) of a composite drive shaft is performed considering three conflicting objectives: fundamental ...
متن کاملExperimental Investigation of Behavior of Glass Fiber Reinforced Concrete (GFRC)
The paper presents the results of casting and testing of 264 GFRC specimens. The glass fibers were 25 mm long, with the aspect ratio (L/D) ranging between 1250 and 3570. The parameters studied were the ratio (by weight) of fibers to cement, i.e. F/C=0%, 1.5%, 3%, and 4.5%, and the ratio of coarse to fine aggregates (gravel to sand), i.e. G/S=1.1, 0.7 and 0.2. In total, 12 mix designs were selec...
متن کاملExperimental Investigation of Behavior of Glass Fiber Reinforced Concrete (GFRC)
The paper presents the results of casting and testing of 264 GFRC specimens. The glass fibers were 25 mm long, with the aspect ratio (L/D) ranging between 1250 and 3570. The parameters studied were the ratio (by weight) of fibers to cement, i.e. F/C=0%, 1.5%, 3%, and 4.5%, and the ratio of coarse to fine aggregates (gravel to sand), i.e. G/S=1.1, 0.7 and 0.2. In total, 12 mix designs were selec...
متن کاملInvestigation of Axial to Lateral Load ratio on the Buckling of Thin Orthotropic Cylindrical Shells
Buckling analysis of thin cylindrical shells is very important due to their production process. Usually longitudinal and transversal stiffeners are used to increase the buckling stiffness. In this paper, considering a thin cylindrical shell with longitudinal and transversal ribs subjected to axial force and lateral pressure, the influence of different aspect of axial force to lateral pressure ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of Belgorod State Technological University named after. V. G. Shukhov
سال: 2017
ISSN: 2071-7318
DOI: 10.12737/article_5a27cb7ed07108.52925064