OPTIMIZATION OF TECHNOLOGICAL TOOL GEOMETRY IN FORMING BIMETALLIC PIECE PARTS
نویسندگان
چکیده
منابع مشابه
Cutting Forces and Tool Wear Investigation for Face Milling of Bimetallic Composite Parts Made of Aluminum and Cast Iron Alloys
Bimetallic parts are used in many industries for weight and cost reduction of workpieces working under high loads and wear. One application for this type of composite material is in automotive industry. In this work the tool wear and cutting forces in the face milling of bimetallic parts made of aluminum and cast iron were investigated. A356 and GG25 alloys that are common materials for bimetal...
متن کاملsimultaneous optimization of machining parameters and tool geometry specifications in turning operation of aisi1045 steel
machining operation is one of the most applicable processes for the manufacturing of industrial parts. usually, the quality of finished part in turning operation is measured in terms of surface roughness. in turn, surface quality is determined by machining parameters and tool geometry specifications. the main objective of this study is to model and optimize machining parameters and tool geometr...
متن کاملInvestigation of Fracture Depth of Al/Cu Bimetallic Sheet in Single Point Incremental Forming Process
Single point incremental sheet forming (SPISF) has demonstrated significant potential to form complex sheet metal parts without using component-specific tools and is suitable for fabricating low-volume functional sheet metal parts economically. In the SPIF process, a ball nose tool moves along a predefined tool path to form the sheet. This work aims to optimize the formability and forming force...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملForming parts over small radii
Stamping simulations usually make the plane stress simplifying assumption. However, this becomes less valid when material draws around features with radius to sheet thickness ratios less than 20. Pereira, Yan & Rolfe (Wear, Vol.265, p.1687 (2008)) predicted that out-of-plane stress equivalent to material yield can occur because a line contact forms briefly at the start of the draw process. The ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Izvestiya Vuzov. Tsvetnaya Metallurgiya (Proceedings of Higher Schools. Nonferrous Metallurgy)
سال: 2015
ISSN: 2412-8783,0021-3438
DOI: 10.17073/0021-3438-2013-4-19-21