Optimization of Three Body Abrasive Wear Behaviour of Stir Cast A356/ ZrSiO4 Metal Matrix Composite
نویسندگان
چکیده
منابع مشابه
DRY SLIDING WEAR BEHAVIOUR OF STIR CAST LM 25/ZrO2 METAL MATRIX COMPOSITES
In the present study, an investigation into wear properties has been carried out to identify the influence of ZrO2 as the reinforcement material on the LM25 MMC composite. Aluminum LM25 is selected as the base material, and it is reinforced with varying proportions of 0, 3, 6, 9, 12 and 15% of zirconia (ZrO2) manufactured by stir casting. Six tensile test and wear test samples were prepared acc...
متن کاملTwo-body and three-body abrasive wear behaviour of polyaryletherketone composites
Single and multipass two-body and three-body abrasive wear behaviour of various polyaryletherketone composites have been carried out by using a pin-on-disc machine and a rubber wheel abrasion test (RWAT) rig. Abrasive wear studies were conducted under different loads and sliding distances. Comparative wear performance of all the composites at different loads shows that specific wear rate (Ko) o...
متن کاملThree-body wear of different composites resins
Introduction: Low resistance of composite resins to abrasion is a primary concern in the application of these materials for posterior restorations which are prone to high occlusal loads. This study compared the wear resistance of three types of composites. Methods: In this laboratory experiment, five specimens of each of the three types of composites (z250, Heliomolar, Opallis) were prepared...
متن کاملAN INVESTIGATION ON ABRASIVE WEAR BEHAVIOUR OF Fe-C-Mo-FeCr COMPOSITE PRODUCED BY POWDER METALLURGY
In this study, the effect of chromium carbide (Cr7C3) on abrasive wear behavior of Fe-C-Mo-FeCr composite was investigated. Composite, which was produced by a powder metallurgy route was containing 3 wt.% Mo, 1.5 wt. % C and 4,8,12 wt. % FeCr with the different particle sizes. In the experiments, wear resistance of samples were determined using different loads by a pin on disc wear tester. Micr...
متن کاملdesign and optimization of metal matrix composite (mmc’s) spur gear
gears are one of the most critical components in power transmission system of an automobile and also many rotating machinery. many studies have been conducted on optimum gear design. the main objective is to design different aluminium metal matrix composite spur gears before and after optimization. aluminium metal matrix material composites are preferred mostly due to their low density. also th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tribology in Industry
سال: 2018
ISSN: 0354-8996,2217-7965
DOI: 10.24874/ti.2018.40.04.10