Optimum Thread Rolling Process that Improves SCC Resistance
نویسندگان
چکیده
منابع مشابه
Optimum Thread Rolling Process proves SGC Resistance
Accelerated testing in environments aggressive for the specific material have shown that fastener threads that are rolled after strengthening heat treatments have improved resistance to SCC initiation. For example, intergranular SCC was produced in one day when machined (cut) threads of high strength steel (ASTM A193 B-7 and A354 Grade 8) were exposed to an aggressive aqueous environment contai...
متن کاملMemory Suppression is an Active Process that Improves Over Childhood
We all have memories that we prefer not to think about. The ability to suppress retrieval of unwanted memories has been documented in behavioral and neuroimaging research using the Think/No-Think (TNT) paradigm with adults. Attempts to stop memory retrieval are associated with increased activation of lateral prefrontal cortex (PFC) and concomitant reduced activation in medial temporal lobe (MTL...
متن کاملOptimum Feedback Controller Design for Tandem Cold Metal Rolling
Controlling the tandem cold rolling of metal strip is a significant challenge to the control engineer. This is due mostly to complex interactions between the process variables, nonlinearities that change with process conditions, and long speed-dependent time delays. The present technology is limited in its capability for improvement in performance. This paper describes a new control strategy th...
متن کاملThread Thread Thread Thread Thread Thread �
We present the design and implementation of Arachne, a threads system that can be interfaced with a communications library for multi-threaded distributed computations. In particular, Arachne supports thread migration between heterogeneous platforms, with dynamic stack size management and recursive thread functions. Arachne is eecient, exible and portable | it is based entirely on C and C++. To ...
متن کاملInvestigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of ASTM International
سال: 2006
ISSN: 1546-962X
DOI: 10.1520/jai13414