Ordering Process in CuPd Alloys during Continuous Heating
نویسندگان
چکیده
منابع مشابه
Ordering process and age-hardening mechanism of CuPd-AuCu pseudo-binary alloys.
Ordering process and age-hardening mechanism of CuPd-AuCu pseudo-binary alloys were examined In alloys with electron-atom ratios (e/a)<0.87, short range ordering was observed in the early stage of aging, thereafter, long range ordering occurred from grain boundaries by heterogeneous ordering mecha nism. Age-hardening of these alloys was attained by the increase in volume fractions of CuPd and/o...
متن کاملPhase Transitions During Continuous Heating of Martensitic CuAlMn Alloys
Phase transitions in CuAlMn alloys containing up to 12 at% Mn and 27 at% A1 continuously heated up to 5500C were studied using differential scanning calorimetry and transmission electron microscopy. Alloys containing less than 4.8 at% Mn exhibit an exothermal heat effect in the range 280 380°C due to y2 precipitation. The additional endothermal peak above 5000C is caused by DO3 disordering. All...
متن کاملDissolution and Precipitation Behaviour during Continuous Heating of Al–Mg–Si Alloys in a Wide Range of Heating Rates
In the present study, the dissolution and precipitation behaviour of four different aluminium alloys (EN AW-6005A, EN AW-6082, EN AW-6016, and EN AW-6181) in four different initial heat treatment conditions (T4, T6, overaged, and soft annealed) was investigated during heating in a wide dynamic range. Differential scanning calorimetry (DSC) was used to record heating curves between 20 and 600 °C...
متن کاملPhase transformation kinetics during continuous heating of and metastable titanium alloys
The effect of heating rate on the phase trans-formation kinetics of a Ti–10V–2Fe–3Al metastable btitanium alloy quenched from the b field is investigated byfast in situ high energy synchrotron X-ray diffraction anddifferential scanning calorimetry. The initial microstructureis formed by a00 martensite and finexath particles distrib-uted in the retained b-phase matrix...
متن کاملSurface effects of ordering in binary alloys
This article reviews the most important achievements in the studies of the compositional (chemical) and magnetic ordering effects in the surface region of single-crystal binary alloys with different bulk structures. These alloys include the non-magnetic and magnetic concentrated substitutional binary systems which have a tendency to ordering (Au–Cu, Cu–Pt, Fe–Pt, Co–Fe, Fe–Ni, Al–Fe, Al–Ni, Pt–...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1982
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.46.3_245