Oxidation-Induced Amorphization of Niobium Precipitates in Zirconium Alloys

نویسندگان

چکیده

This article is a commentary on our previous work entitled “Reassessment of oxidation-induced amorphization and dissolution Nb precipitates in Zr-Nb nuclear fuel cladding tube”, published Acta Materialia 2017. The highlight this 2017 paper discovery that solid-state can occur even when the motion atoms (or more precisely, all constituent elements amorphous material) not frozen-in. Although judging from highlight, fundamental study materials, it was originally performed under an engineering research program irrelevant to amorphous. inside story revealed: how such born out research.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

EELS study of niobium carbo-nitride nano-precipitates in ferrite.

Micro-alloying steels allow higher strength to be achieved, with lower carbon contents, without a loss in toughness, weldability or formability through the generation of a fine ferrite grain size with additional strengthening being provided by the fine scale precipitation of complex carbo-nitride particles. Niobium is reported to be the most efficient micro-alloying element to achieve refinemen...

متن کامل

Stresses induced in alloys by selective oxidation

Consider a substitutional solution of two metallic elements A and B. When the alloy is exposed to air at an elevated temperature, A oxidizes, but B does not. In the alloy, the two elements diffuse in opposite directions, but usually at different rates; the nonreciprocal diffusion is known as the Kirkendall effect. At the oxide-alloy interface, metallic atoms may either emit from or inject into ...

متن کامل

Fate of hydrogen upon oxidation of zirconium alloys by water: Mechanistic insights from first principles calculations

Polyvinyl chloride (PVC) is one of the world’s most widely produced polymers and it is used in a wide range of areas such as building, transport, packaging, electrical/electronic and healthcare. Manufacturing of PVC products is dependent on several additives, e.g. plasticizers, heat stabilizers and flame retardants. To reduce the migration of additives in PVC products the incorporation of a nan...

متن کامل

Procedure for Conducting Breakaway Oxidation Tests with Zirconium-based Cladding Alloys

4. Sample Preparation and Characterization 7 4.1 Hydrogen-content determination for as-fabricated samples 7 4.2 Minimum sample lengths for oneand two-sided oxidation tests 7 4.3 End-cap mass and welding procedure for one-sided oxidation test samples 7 4.4 Length, outer diameter, and wall thickness measurements 7 4.5 Pre-test cleaning with chemical detergent or organic solvent and rinsing 8 4.6 ...

متن کامل

X-ray Analysis of Precipitates Formed in Copper-base Alloys

The formation and growth process of precipitates in Cu-Ni-Si alloys during aging were investigated by anomalous small angle scattering (ASAXS) and X-ray absorption fine structure (XAFS). ä-Ni2Si precipitates with wide nanometer size distribution were formed in the Cu-Ni-Si alloys after a long aging time of 10 s. However, the addition of a small amount of Fe appears to reduce the wide-size distr...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of The Society of Materials Science, Japan

سال: 2023

ISSN: ['0514-5163', '1880-7488']

DOI: https://doi.org/10.2472/jsms.72.237