Parameter Estimation of a Single-Phase Boost PFC Converter with EMI Filter Based on an Optimization Algorithm
نویسندگان
چکیده
This paper proposes an approach to estimate the parameters of AC–DC boost power factor corrector converter that includes EMI filter. To this end, once topology was known, values passive elements were identified from measurements at input and output terminals converter. The based on trust region nonlinear least squares algorithm. steady-state transient signals input/output acquired non-intrusively without any internal modification circuitry. accuracy proposed parameter identification determined by comparing estimated with those provided manufacturer, measured obtained a simulation model included parameters. results presented in prove approach, which can be extended other converters filters.
منابع مشابه
Starting strategies of three-phase single-stage PFC converter based on isolated full-bridge boost topology
Starting strategies were investigated for a three-phase single-stage power factor correction (PFC) converter. Starting process and mechanism of input over current was analyzed in detail. A lossy method was proposed and designed in which a resistor was connected in series with the filter capacitor to increase effective value of output voltage. Based on them, the boost inductors were replaced by ...
متن کاملA Low Cost Single-Switch Bridgeless Boost PFC Converter
Received Jan 2, 2014 Revised Mar 12, 2014 Accepted Mar 25, 2014 This paper proposes the single-switch bridgeless boost power factor correction (PFC) converter to achieve high efficiency in low cost. The proposed converter utilizes only one active switching device forPFC operation as well as expecting higher efficiency than typical boost PFC converters. On the other hand, the implementation cost...
متن کاملEffects of Nonlinearity in Input Filter on the Dynamic Behavior of an Interleaved Boost PFC Converter
A power factor correction (PFC) converter with interleaved multi-channel topology is gaining increasing attention due to its ability in reducing input and output current ripples, but an Electromagnetic Interference (EMI) noise filter is still required for suppressing the large high-frequency switching noise that could potentially degrade the input power quality of the supplying grid and cause m...
متن کاملThermal and EMI Modeling and Analysis of a Boost PFC Circuit Designed Using a Genetic-based Optimization Algorithm
The boost power factor correction (PFC) circuit is a common circuit in power electronics. Through years of experience, many designers have optimized the design of these circuits for particular applications. In this study, a new design procedure is presented that guarantees optimal results for any application. The algorithm used incorporates the principles of evolution in order to find the best ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics
سال: 2021
ISSN: ['2079-9292']
DOI: https://doi.org/10.3390/electronics10111231