Parameter Estimation of LFM Signal in Low Signal-to-Noise Ratio Using Cross-Correlation Function

نویسندگان

چکیده

The pulse with intra-pulse modulation plays an important role in the design of radar systems. first class signals type is linear frequency technique. used to resolve range resolution problems. This paper provides a new algorithm for detecting at low signal-to-noise ratio. core idea proposed method firstly analyse via Fast Fourier Transform; and then accumulate all energy achieve signal detection using cross-correlation methods. showed better results comparison current algorithms, which are estimate parameters

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Signal-to-Noise Ratio Estimation

Of the many measures that characterize the performance of a communication receiver, signal-to-noise ratio (SNR) is perhaps the most fundamental in that many of the other measures directly depend on its knowledge for their evaluation. In the design of receivers for autonomous operation, it is desirable that the estimation of SNR take place with as little known information as possible regarding o...

متن کامل

Signal-to-Noise Ratio Estimation in Passive Correlation-Based Imaging

We consider here the problem of imaging using passive incoherent recordings due to ambient noise sources. The first step towards imaging in this configuration is the computation of the cross-correlations of the recorded signals. These cross-correlations are computed between pairs of sensors (receivers) and they contain very important information about the background medium. Indeed, it was shown...

متن کامل

Single-image signal-to-noise ratio estimation.

A method for estimating the signal-to-noise ratio from a single image is presented in this paper. The autocorrelation-based technique requires that image details be correlated over distances of a few pixels, while the noise is assumed to be uncorrelated from pixel to pixel. The latter is shown to be a good approximation in the case of scanning electron microscope (SEM) images provided that the ...

متن کامل

Blind Frequency and Symbol Rate Estimation for MSK Signal under Low Signal-to-Noise Ratio ⋆

We investigate a novel blind estimator combination of carrier frequency and symbol rate of an complex MSK modulation under low signal-to-noise ratio (SNR). The carrier frequency is estimated by using Modified Rife frequency estimator at first and the referenced signal is constructed consequently. Then, the received signal is transformed to baseband by means of correlation with the referenced si...

متن کامل

Detection and Parameter Estimation of Multicomponent LFM Signal Based on the Cubic Phase Function

A new algorithm for the detection and parameters estimation of LFM signal is presented in this paper. By the computation of the cubic phase function (CPF) of the signal, it is shown that the CPF is concentrated along the frequency rate law of the signal, and the peak of the CPF yields the estimate of the frequency rate. The initial frequency and amplitude can be obtained by the dechirp techniqu...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Advances in Electrical and Electronic Engineering

سال: 2021

ISSN: ['1804-3119', '1336-1376']

DOI: https://doi.org/10.15598/aeee.v19i3.4071