Particle size dependent sinterability and magnetic properties of recycled HDDR Nd–Fe–B powders consolidated with spark plasma sintering
نویسندگان
چکیده
منابع مشابه
Magnetic properties of ball-milled SrFe12O19 particles consolidated by Spark-Plasma Sintering
The room-temperature magnetic properties of ball-milled strontium hexaferrite particles consolidated by spark-plasma sintering are strongly influenced by the milling time. Scanning electron microscopy revealed the ball-milled SrFe12O19 particles to have sizes varying over several hundred nanometers. X-Ray powder-diffraction studies performed on the ball-milled particles before sintering clearly...
متن کاملFull densification of Molybdenum powders using Spark Plasma Sintering
Pure molybdenum powder was sintered using Spark Plasma Sintering under various temperatures, and holding times, under a pressure of 77 MPa and a heating rate at 700°C/min. After sintering, a carbide layer was observed at the surface. The carbide layer thickness, the relative density of the sample as well as the microhardness and the grain size of Mo were measured. The carbide thickness depends ...
متن کاملSpark-plasma-sintering (SPS) of nanostructured titanium carbonitride powders
Spark-Plasma-Sintering (SPS) compaction experiments of nanostructured titanium carbonitride powders have been performed at 1600°C and 1800°C (sintering time = 1 min). The as-received nanostructured samples have been synthesized by rapid condensation from the gas-phase (high frequency plasma). The sintering results were compared with data obtained by various conventional sintering techniques suc...
متن کاملSpark Plasma Sintering of Commercial Zirconium Carbide Powders: Densification Behavior and Mechanical Properties
Commercial zirconium carbide (ZrC) powder is consolidated by Spark Plasma Sintering (SPS). Processing temperatures range from 1650 to 2100 °C. Specimens with various density levels are obtained when performing single-die SPS at different temperatures. Besides the single-die tooling setup, a double-die tooling setup is employed to largely increase the actual applied pressure to achieve higher de...
متن کاملNanostructured Al-ZrAl3 materials consolidated via spark plasma sintering: Evaluation of their mechanical properties
Aluminium based nanostructured materials with additions of 0.5, 1 and 1.5 weight% of zirconium have been produced and sintered using the spark plasma sintering technique in order to promote the nucleation of ZrAl3 platelets. The mechanical behaviour of all these nanocomposites was determined by means of the Small Punch Test. Zirconium additions significantly decrease the mechanical properties o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Rare Earths
سال: 2020
ISSN: 1002-0721
DOI: 10.1016/j.jre.2019.02.010