Particle Size Distribution of Phosphors and their Aggregation in Solution. I. Measurement and Analysis of Particle Size Distribution by means of Microscopic Method.
نویسندگان
چکیده
منابع مشابه
Measurement of Particle Size Distribution by Acoustic Emission Method
Continuous measurement of size distribution of particles is the necessary parameter regarding the control of some specific production processes. A possible solution is the use of the acoustic emission method which is based on the measurement and analysis of pressure pulses generated by an impact of solid particles against a solid obstacle. Our paper focuses on the practical verification of the ...
متن کاملlanguage learning strategies and vocabulary size of iranian efl learners
learning a second or foreign language requires the manipulation of four main skills, namely, listening, reading, speaking, and writing which lead to effective communication. it is obvious that vocabulary is an indispensible part of any communication, so without a vocabulary, no meaningful communication can take place and meaningful communication relies heavily on vocabulary. one fundamental fac...
Effects of Temperature and Particle Size Distribution on Barite Reduction by Carbon monoxide Gas
In this research, a mineral barite powder was reduced by carbon monoxide gas and the effects of reduction time and temperature was investigated as well as barite particle size. Results showed that the best result would be feasible when the barite particle sizes are between (-70 +100) in mesh scale. The barite reduction could reach the maximum level (98%) after reduction by carbon monoxide at 85...
متن کاملEffect of Particle Size Distribution and Chemical Composition on Properties of Magnesia Chromite Bricks
The present study was undertaken to improve the quality and increase the life time of magnesia-chromite refractory bricks used in the copper and lead industries. The results show that a decrease in the amount of large chromite particles in the formulation improves the thermomechanical properties and also reduces the slag penetration in the bricks. In addition it was also observed that the use o...
متن کاملCompressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents
In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Society of Chemical Industry, Japan
سال: 1954
ISSN: 0023-2734,2185-0860
DOI: 10.1246/nikkashi1898.57.89