Particle wall-loss correction methods in smog chamber experiments
نویسندگان
چکیده
منابع مشابه
Outdoor smog chamber experiments in Mexico
Towards the end of the 1940s the air’s contamination began in Mexico. It just happened when Mexico starts its industrial growing. During these years the population increased notably. Industrial growing in the 1950s was carried through an urbanization process (Restrepo, 1992). Mexico City was the first because it had industries, services, government offices, culture attractions and higher educat...
متن کاملConstraining uncertainties in particle-wall deposition correction during SOA formation in chamber experiments
The effect of vapor-wall deposition on secondary organic aerosol (SOA) formation has gained significant attention; however, uncertainties in experimentally derived SOA mass yields due to uncertainties in particle-wall deposition remain. Different approaches have been used to correct for particle-wall deposition in SOA formation studies, each having its own set of assumptions in determining the ...
متن کاملBubble Chamber Experiments on Charmed Particle Lifetimes
The three current bubble chamber experiments on charmed particle lifetimes are compared. Their most recently released results are discussed. Although single charmed decay vertices have been seen in bubble chambers before, this discussion will cover the three current experiments. Two are at CERN and the third at SLAC. All use bubble chambers with relatively high resolution photographic technique...
متن کاملSmog Chamber Studies of Particle Formation from the Oxidation of Terpenes
Important aspects of the current research on atmospheric aerosols have recently been highlighted by Andreae and Crutzen (1997). The authors state that secondary organic aerosols, formed by the oxidation of VOCs emitted from biogenic sources, probably account for a significant fraction of the particulate matter in rural and remote continental air masses. Monoterpenes (C10H16), which constitute o...
متن کاملAngular Dependence of Wall Correction for Cylindrical Cavity Chamber
Abstract The cylindrical graphite cavity chambers are used for primary standard of air kerma rate of Co-60 and Cs-137. We measured wall attenuation correction factor (Kat) at several irradiation angles using extrapolation technique because of angular dependence. From these results, it can be seen that it is insufficient technique for evaluation of Kat. The Monte Carlo simulations were also done...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Atmospheric Measurement Techniques
سال: 2018
ISSN: 1867-8548
DOI: 10.5194/amt-11-6577-2018