Passive Vibration Isolation-Reduction System by Linear Friction Damper
نویسندگان
چکیده
منابع مشابه
Retrofitting A Passive Vibration Isolation System with Zero-Compliance Modules
A vibration isolation module with zero-power magnetic suspension is developed to retrofit a passive vibration isolation system to improve the performance against direct disturbance. In the module, the zero-power magnetic suspension mechanism is connected in series with a normal spring through a middle mass. This structure can generate zero compliance to direct disturbance while the transmitted ...
متن کاملPassive vibration isolation using a Roberts linkage
November2002 The article presents a new ultra-low frequency passive vibration isolation device as part of the pre-isolation stage for AIGO (Australian
متن کاملDesign and Evaluation of Hydro-Pneumatic Friction Damper Suspension System
Perceived comfort level and ride stability are the two most important factors in the evaluation of suspension system in a mobile vehicle. It is extremely difficult to simultaneously maintain a high standard of vehicle ride, handling and body control in the vehicle by using conventional passive suspension system. However, the use of active suspensions would result in better comforts than the pas...
متن کاملLinear and Nonlinear Controller Contrast for the Vibration Isolation System
The analysis of smart spring vibration isolation system is analyzed through MATLAB simulation. The results show suppressing dominant vibration mode of platform. In the paper controllers developed for the smart spring are linear and nonlinear. This paper deals with MIMO system analysis of low frequency dominant modes, which are critical, examined first by linear controller techniques and then wi...
متن کاملFully Adaptive Semi-active Control of Vibration Isolation by Mr Damper
This paper is concerned with a new fully adaptive control scheme for vibration isolation using a semi-active MR damper installed between ground and first floor, which is composed of two adaptive controllers. One is an adaptive inverse controller which can give necessary input voltage to MR damper so as to generate specified reference damping force to be acted on a controlled structure. The inpu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2004
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.70.3419