PENGARUH SUDUT NOZZLE TERHADAP PERMANENT PRESSURE DROP AND DISCHARGE COEFFICIENT PADA NOZZLE FLOW METER

Reacting Nozzle Flow

The two limits, “frozen” and “equilibrium” flow share an important property: both are isentropic flows (if we ignore friction or heat losses). This is because, in the frozen case no chemical change during expansion), there are no rate processes at all occurring, the molecules preserving their identity all the way, while in the equilibrium case, in which reactions do occur, their rate is so high...

Investigation the effects of injection pressure and compressibility and nozzle entry in diesel injector nozzle’s flow

Investigating nozzle’s orifice flow is challenging both experimentally and theoretically. This paper focuses on simulating flow inside diesel injector nozzle via Ansys fluent v15. Validation is performed with experimental results from Winkhofler et al (2001). Several important parameters such as mass flow rate, velocity profiles and pressure profiles are used for this validation. Results includ...

Noise Generation in the Near-Nozzle Region of a Chevron Nozzle Jet Flow

This paper reports on the simulation of the near-nozzle region of a moderate Reynolds number cold jet flow exhausting from a chevron nozzle. The chevron nozzle considered in this study is the SMC001 nozzle experimentally studied by the researchers at the NASA Glenn Research Center. This nozzle design contains six symmetric chevrons that have a five-degree penetration angle. The flow inside the ...

Unsteady Transonic Nozzle Flow with Heat Addition

Instability of shock-induced nozzle flow separation

We investigate experimentally the causes of jet plume instability and enhanced mixing observed in the exhaust of shock-containing convergent-divergent nozzles. Key features of the internal flow are the separation shock, separation shear layers, and pattern of alternating expansion and compression waves downstream of the shock. We focus on two possible reasons for this instability—the motion of ...