Performance Analysis of Shell and Tube Heat Exchanger by using AL2O3 & CuO Nanofluid
نویسندگان
چکیده
منابع مشابه
Economic Optimization of Shell and Tube Heat Exchanger Using Nanofluid
Economic optimization of shell and tube heat exchanger (STHE) is presented in this paper. To increase the rate of heat transfer, copper oxide (CuO) nanoparticle is added into the tube side fluid and their optimum results are compared with the case of without additive nanoparticle. Total annual cost (TAC) is selected as fitness function and nine decision variables related to the heat exchanger p...
متن کاملAnalysis of Gasketed-plate Heat Exchanger Performance Using Nanofluid
A heat exchanger using nanofluid needs to operate at optimum mass concentration level to get the maximum heat transfer performance. A numerical analysis is performed on the heat transfer and pressure drop of water-based γ-Al2O3 nanofluid gasketed-plate heat exchanger to specify its optimum conditions. Cold water will be heated by γ-Al2O3/water nanofluid. The results showed that optimal volume c...
متن کاملEffect of baffle oientation on shell tube heat exchanger performance
In this paper, fluid flow and heat transfer in the laboratory (small size) shell tube heat exchanger are analysed by computational fluid dynamic software. In this type of shell tube heat exchanger baffles with different angles of rotation: 00 (horizontal segmental baffle), 150 (from horizontal), 300, 450, 600, 750, 900 (vertical segmental baffle) is used. Effect of baffle orientation on shell t...
متن کاملevaluation of γ-al2o3/n-decane nanofluid performance in shell and tube heat recovery exchanger in a biomass heating plant
the performance of a γ-al 2 o 3 /n-decane nanofluid shell-and-tube heat exchanger in a biomass heating plant is analyzed to specify the optimum condition based on the maximum heat transfer rate and performance index for wide range of nanoparticle volume fraction (0–7%). compared with pure n-decane, the obtained results in this research show that by using γ-al 2 o 3 /n-decane nanofluid ...
متن کاملAnalysis of Heat Transfer Coefficient of CuO/Water Nanofluid using Double Pipe Heat Exchanger
Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2018
ISSN: 2321-9653
DOI: 10.22214/ijraset.2018.7016