Performance estimation of beryllium under ITER relevant transient thermal loads
نویسندگان
چکیده
منابع مشابه
TOPOLOGY OPTIMIZATION OF STRUCTURES UNDER TRANSIENT LOADS
In this article, an efficient methodology is presented to optimize the topology of structural systems under transient loads. Equivalent static loads concept is used to deal with transient loads and to solve an alternate quasi-static optimization problem. The maximum strain energy of the structure under the transient load during the loading interval is used as objective function. The objective f...
متن کاملHollow Piezoelectric Cylinder under Transient Loads
In this paper, transient solution of two dimensional asymmetric thermal and mechanical stresses for a hollow cylinder made of piezoelectric material is developed. Transient temperature distribution, as function of radial and circumferential directions and time with general thermal boundary-conditions, is analytically obtained, using the method of separation of variables and<br...
متن کاملBeryllium and graphite performance in ITER during a disruption *
Plasma disruptions are considered one of the most limiting factors for successful operation of magnetic fusion reactors. During a disruption, a sharp, rapid release of energy strikes components such as the divertor or limiter plates. Severe surface erosion and melting of these components may then occur. The amount of material eroded from both ablation and melting is important to the reactor des...
متن کاملTransient internal forced convection under dynamic thermal loads: in clean-tech and automotive applications
Developing next generation transient heat exchangers is a transformative technology for efficient ther-mal management of advanced power electronics and electric machines (APEEM) inside hybrid electric,electric, and fuel cell vehicles as well as renewable energies (wind, solar, tidal). Optimal design criteriafor such dynamic heat exchangers should be achieved through addressing inter...
متن کاملPredicting Fusing Current for Encapsulated Wire Bonds under Transient Loads
For high power IC chips, as device size inevitably decreases, the wire diameter unfortunately must decrease due to the need of finer pitch wires. Fusing or melting of wirebonds thus increasingly becomes one of the potential failure issues for such IC’s. Experiments were performed under transient loads on dummy packages having aluminum, gold, or copper wires of different dimensions. A finite ele...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Materials and Energy
سال: 2019
ISSN: 2352-1791
DOI: 10.1016/j.nme.2018.12.026