Performance evaluation of efficient combinational logic design using nanomaterial electronics
نویسندگان
چکیده
منابع مشابه
Power Optimized Combinational Logic Design
In this paper we address the problem of minimization of power consumption in combinational circuits by minimizing the number of switching transitions at the output nodes of each gate. A powerful combinational logic optimization method using k-map is presented here that is based on disjoint implicants (implicates) of a function. More than 10% reduction in switching activity has been obtained wit...
متن کاملEvolutionary design of combinational logic circuits using VRA processor
This paper presents a virtual reconfigurable architecture (VRA)-based evolvable hardware for automatic synthesis of combinational logic circuits. The VRA processor is implemented on a Xilinx FPGA and works through two-stage evolutions: (1) finding a functional circuit, and (2) minimizing the number of gates used. To optimize the algorithm performance in the evolutionary process, a self-adaptive...
متن کاملEvolutionary Multiobjective Design of Combinational Logic Circuits
In this paper, we propose an evolutionary multiobjective optimization approach to design combinational logic circuits. The idea is to use a population-based technique that considers outputs of a circuit as equality constraints that we aim to satisfy. A small sub-population is assigned to each objective. After one of these objectives is satisfied, its corresponding sub-population is merged with ...
متن کاملdesign of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولSwitching Activity Minimization in Combinational Logic Design
Abstract: In this paper we focus on the reduction of switching activity in combinational logic circuits. An algorithmic approach using k-map has been proposed which modifies the normal optimal solution obtained from k-map to reduce its switching activity. More than 10% reduction in switching activity has been observed using our method. The final solution gives a good trade off between cost and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Cogent Engineering
سال: 2017
ISSN: 2331-1916
DOI: 10.1080/23311916.2017.1349539