Performance Evalution Method of CMOS Crystal Oscillator Circuits
نویسندگان
چکیده
منابع مشابه
Single Transistor Crystal Oscillator Circuits
Understanding a simple crystal oscillator transmitter circuit The transistor in common emitter configuration contributes -180 deg phase shift between base. Write short notes on (i) RC Oscillator (ii) Wien bridge Oscillator (iii) Crystal It consists of a conventional single transistor amplifier and a RC phase shift network. The wien-bridge oscillator is the standard oscillator circuit for all fr...
متن کاملPerformance of CMOS Ring Oscillator
This experiment investigates various methods of determining the delay in CMOS gates. Direct measurement, ring oscillator and simulation methods are used and compared. A stroboscopic pulse generator was also examined during the experiment. Finally, the effects of supply voltage and output load on gate delay were examined. LOW Input (pin 3) Square wave input (pin 39) Output (pin 5) Square wave in...
متن کاملPolynomial Metamodel Based Fast Optimization of Nano-CMOS Oscillator Circuits
Modern consumer electronics are designed as Analog/Mixed-Signal Systems-onChip (AMS-SoCs). In an AMS-SoC, the analog and mixed-signal portions have not received systematic attention due to their complex nature and the fact that their optimization and simulation consume significant portions of the design cycle time. This paper presents a new approach to reduce the design cycle time by combining ...
متن کاملDesign of Low Power CMOS Crystal Oscillator with Tuning Capacitors
A low power CMOS crystal oscillator was proposed with high accuracy by tuning capacitors. Based on the analysis concerning power consumption, start-up time, and frequency stability of the crystal oscillator, an amplitude regulation circuit was employed to limit the current consumption. Simulation results showed the measured currents of 27 μA and 20 μA with and without the output stage under 1.5...
متن کاملReliability-aware design method for CMOS circuits
Reliable design flows for integrated CMOS circuits must take into account all effects that influence whole circuits or several single transistors. For larger technology nodes it was sufficient to design a circuit with respect to pure electrical properties like voltages, currents or capacitance. However, the progressive downscaling of CMOS transistors necessitates a design flow that is able to c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Electronics, Information and Systems
سال: 1988
ISSN: 0385-4221,1348-8155
DOI: 10.1541/ieejeiss1987.108.9_692