Performance of Ferro-Cement Strengthened Unreinforced Masonry Walls against Reverse Cyclic Loading
نویسندگان
چکیده
منابع مشابه
Effective stiffness of unreinforced brick masonry walls
Code design of Unreinforced Masonry (URM) buildings is based on elastic analysis, which requires as input parameter the effective stiffness of URM walls. Current approaches estimate the effective stiffness as fixed ratio of the gross sectional stiffness but comparisons with experimental results have shown that this does not yield satisfactory predictions. In this paper, a recently developed ana...
متن کاملLimit states of modern unreinforced clay brick masonry walls subjected to in-plane loading
Recent research showed that the in-plane horizontal displacement capacity of unreinforced masonry (URM) walls depends on numerous factors that are not yet captured by current empirical drift capacity models; e.g., axial stress, shear span, geometry of the walls and the material used. In order to improve the performance-based assessment of URM wall buildings, future research should aim at develo...
متن کاملDamage Accumulation in Unreinforced Masonry Due to Seismic Loading
Masonry has low cohesive strength and is susceptible to the brittle failure, when subjected to induced tensile stresses. It fails due to lateral tensile stresses even when masonry prisms are tested in uni-axial static compression and the stress-strain curve remains almost linear up to failure. Although masonry normally resists compressive forces, under lateral in-plane cyclic loads some parts o...
متن کاملEffect of Unreinforced Masonry Infill Walls on Seismic Performance of Reinforced Concrete Framed Structures
Unreinforced Masonry infill walls (URM) are commonly used in the Reinforced Concrete (RC) framed structures as interiors and exteriors partition walls. Although they usually are not considered in the structural analysis and design, their influence on the seismic performance of the framed structures is significant. A common practice in the modern and old RC buildings is to remove the URM walls i...
متن کاملFlexural Tension in Unreinforced Masonry
Unreinforced masonry is that in which the tensile strength of the masonry is taken into consideration in design. Allowable out-of-plane tensile stress values are a function of the mortar type, such as Portland cement/lime mortar vs. masonry cement mortar or type M or S mortar vs. type N mortar. The allowable tensile stress is also a function of the masonry construction, such as tension parallel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineer: Journal of the Institution of Engineers, Sri Lanka
سال: 2020
ISSN: 2550-3219,1800-1122
DOI: 10.4038/engineer.v52i4.7345