Permittivity and Conductivity Measured Using a Novel Toroidal Split-Ring Resonator
نویسندگان
چکیده
منابع مشابه
Mode jumping of split-ring resonator metamaterials controlled by high-permittivity BST and incident electric fields
We investigate the resonant modes of split-ring resonator (SRR) metamaterials that contain high-permittivity BST block numerically and experimentally. We observe interesting mode-jumping phenomena from the BST-included SRR absorber structure as the excitation wave is incident perpendicularly to the SRR plane. Specifically, when the electric field is parallel to the SRR gap, the BST block in the...
متن کاملNotched UWB bandpass filter using complementary single split ring resonator
In this paper, a simple method to obtain a notch in the ultra-wideband (UWB) bandpass filter is presented. UWB bandpass filter is designed using ground plane aperture technique. To reject the undesired wireless local area network (WLAN) signals, a complementary single split ring resonator (CSSRR) is placed under the coupled lines of the bandpass filter. The CSSRR has flat insertion loss and goo...
متن کاملFrequency Switching of PIFA Using Split Ring Resonator
In this paper, a PIFA loaded with split ring resonator (SRR) is presented, in which frequency switching is performed by varying the radius of split rings. The proposed Planar invertedF antenna (PIFA) without metamaterial resonates at 7.46 GHz with return loss of -23.71 dB, gain value 5.41 dBi and bandwidth 361.8 MHz. Proposed PIFA structures with metamaterial loading resonates at multiple frequ...
متن کاملDesign of Hexagonal Split Ring Resonator using HFSS
In this paper, Hexagonal Split Ring Resonator (HSRR) and Square Split Ring Resonator (SSRR) are designed using HFSS simulation software. Both split ring resonators are based on the Metamaterial and same parameters. Then after compare the simulation result of HSRR and SSRR. HFSS simulation of the Hexagonal SRR shows improved Return Loss and VSWR i.e. -44.7 dB and 1 respectively compare to Square...
متن کاملImproved Split - Ring Resonator for Microfluidic Sensing
We present a method of making low loss split-ring resonators for microfluidic sensing at microwave frequencies using silver coated copper wire. We show that a simple geometric modification and the use of square cross-section wire give greater electric field confinement in the capacitive region of the resonant sensor. We use a combination of theoretical analysis, finite element simulations and e...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Microwave Theory and Techniques
سال: 2017
ISSN: 0018-9480,1557-9670
DOI: 10.1109/tmtt.2016.2645147