Phase diagrams and ternary compounds of the Al-Mg-Cr and the Al-Mg-Mn systems in Al-rich side
نویسندگان
چکیده
منابع مشابه
FRACTIONAL RECRYSTALLIZATION KINETICS IN DIRECTLY COLD ROLLED Al-Mg, Al-Mg-Sc AND Al-Mg-Sc-Zr ALLOY
The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...
متن کاملTHERMAL ANALYSIS AND KINETICS OF THE PRECIPITATION IN WROUGHT Al-Mg, Al-Mg-ScAND Al-Mg-Sc-Me (Me=Zr, Ti) ALLOYS
Precipitation behaviour of wrought Al-6Mg alloys with ternary scandium and quaternary zirconium and titanium has been studied. Hardness measurements and resistivity studies are employed to assess the precipitation behaviour of scandium doped Al-6Mg alloy without or with quaternary additions of zirconium and titanium. Further, the kinetics of precipitations are studied by differential scanning c...
متن کاملMg isotopic heterogeneity, Al-Mg isochrons, and canonical Al ⁄Al in the early solar system
There is variability in the Mg isotopic composition that is a reflection of the widespread heterogeneity in the isotopic composition of the elements in the solar system at approximately 100 ppm. Measurements on a single calcium-aluminum-rich inclusion (CAI) gave a good correlation of Mg ⁄ Mg with Al ⁄ Mg, yielding an isochron corresponding to an initial (Al ⁄ Al)o = (5.27 ± 0.18) · 10 and an in...
متن کاملStudy on Mg/Al Weld Seam Based on Zn–Mg–Al Ternary Alloy
Based on the idea of alloying welding seams, a series of Zn-xAl filler metals was calculated and designed for joining Mg/Al dissimilar metals by gas tungsten arc (GTA) welding. An infrared thermography system was used to measure the temperature of the welding pool during the welding process to investigate the solidification process. It was found that the mechanical properties of the welded join...
متن کاملCASTABILITY OF Al-Li-Mg AND Al-Li-Cu-Mg ALLOYS
The objective of the present work is to study the casting characteristics of various A1-Li alloys, which include fluidity and strengths of the alloys and their interaction with cast molds. Materials investigated are Al-Li-Mg and Al-Li-Cu-Mg alloys with Li content of 2.5 wt%. The results show that sand molds with resin binders are good for A1-Li casting. Ceramic coatings can further reduce the m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1973
ISSN: 0451-5994
DOI: 10.2464/jilm.23.202