Photocatalytic Preparation of Cuprous Oxide Crystals Using TiO<SUB>2</SUB> Catalyst
نویسندگان
چکیده
منابع مشابه
Cupric oxide inclusions in cuprous oxide crystals grown by the floating zone method
Phase-pure cuprous oxide (Cu2O) crystals are difficult to grow since cupric oxide can form within the crystal as the crystal is cooled to ambient conditions. Vacancies are the solute which causes precipitation of macroscopic defects. Therefore, even when a mostly phase-pure single crystal is used as a feed rod, cupric oxide inclusions persist in the recrystallized solid. Control of the thermal ...
متن کاملPreparation and Instability of Nanocrystalline Cuprous Nitride.
Low-dimensional cuprous nitride (Cu3N) was synthesized by nitridation (ammonolysis) of cuprous oxide (Cu2O) nanocrystals using either ammonia (NH3) or urea (H2NCONH2) as the nitrogen source. The resulting nanocrystalline Cu3N spontaneously decomposes to nanocrystalline CuO in the presence of both water and oxygen from air at room temperature. Ammonia was produced in 60% chemical yield during Cu...
متن کاملRemoval of imidacloprid insecticide in the photocatalytic activation of proxymonosulfate with modified magnesium oxide as catalyst using ultraviolet A
Background and Objective: Imidacloprid, a neonicotinide plant toxin, is used as an insecticide in agriculture. Due to its high degradation resistance and water solubility it is of highly concerns. Therefore, the aim of this study was to investigate the degradation of imidacloprid by modified magnesium oxide catalyst under irradiation of light and peroxymonosulfate. Materials and Methods: In th...
متن کاملPreparation of Cuprous Oxide Mesoporous Spheres with Different Pore Sizes for Non-Enzymatic Glucose Detection
Mass transfer plays a significant role in a sensor's performance, because the substrate can be detected only when it contacts with the active catalytic surface. In this work, cuprous oxide mesoporous nanospheres (Cu₂O MPNS) with different pore size distributions are fabricated and applied as electrocatalysts for glucose detection. The small pore Cu₂O (SP-Cu₂O, mean pore size of 5.3 nm) and larg...
متن کاملPreparation of 3D nanoporous copper-supported cuprous oxide for high-performance lithium ion battery anodes.
Three-dimensional (3D) nanoporous architectures can provide efficient and rapid pathways for Li-ion and electron transport as well as short solid-state diffusion lengths in lithium ion batteries (LIBs). In this work, 3D nanoporous copper-supported cuprous oxide was successfully fabricated by low-cost selective etching of an electron-beam melted Cu(50)Al(50) alloy and subsequent in situ thermal ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 2002
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.66.9_958