PID Controller Tuning via Dominant Pole Placement in Comparison with Ziegler-Nichols Tuning
نویسندگان
چکیده
منابع مشابه
Ziegler-nichols Type Tuning Rules for Fractional Pid Controllers
This paper presents two sets of tuning rules for fractional PIDs that rely solely on the same plant time-response data used by the first Ziegler-Nichols tuning rule for (usual, integer) PIDs. Thus no model for the plant to control is needed; only an Sshaped step response is. These rules are quadratic and their results compare well with those obtained with rule-tuned integer PIDs. INTRODUCTION C...
متن کاملPid Controller Design by Modified Ziegler-nichols Method
The paper presents PID controller design using modification of the Aström and Hägglund’s generalized Ziegler-Nichols rules. The design procedure consists in shifting the plant critical point into a specific point. Its position is defined by desired performance specification in term of achieving maximum overshoot and specified settling time of the closed-loop response or phase margin. The method...
متن کاملComparison of PID Controller Tuning Methods
Proportional, Integral and derivative (PID) controllers are the most widely-used controller in the chemical process industries because of their simplicity, robustness and successful practical application. Many tuning methods have been proposed for PID controllers. Our purpose in this study is comparison of these tuning methods for single input single output (SISO) systems using computer simulat...
متن کاملThe Anthropomorphic Robot Arm Joint Control Parameter Tuning Based on Ziegler Nichols PID
In order to get the anthropomorphic robot accurate parameters of the upper limb joint control motor, a method based on Ziegler Nichols-frequency response of the adaptive PID controller is proposed. The control circuit identifies online important critical frequency response characteristics of process object through input and output data in the normal process operation, and then the system online...
متن کاملGuaranteed Dominant Pole Placement with PID Controllers
Pole placement is a well-established design method for linear control systems. Note however that with an output feedback controller of low-order such as PID one cannot achieve arbitrary pole placement for a high-order or delay system, and then partially or hopefully, dominant pole placement becomes the only choice. To the best of the authors’ knowledge, no method is available in the literature ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC-PapersOnLine
سال: 2019
ISSN: 2405-8963
DOI: 10.1016/j.ifacol.2019.12.204