Piezoelectric and Dielectric Properties of Low Temperature Sintering (K0.5Na0.5)NbO3Ceramics according to Sintering Aid Li2CO3
نویسندگان
چکیده
منابع مشابه
Low-temperature sintering of MnO2-doped PZT–PZN Piezoelectric ceramics
The effect of MnO2 addition on the microstructural evolution and piezoelectric properties of low temperature sinterable PZT–PZN ceramics was investigated. When a small amount of MnO2 (≤0.5 wt% ) was added, the Mn ions were homogeneously dissolved in the PZT– PZN ceramics, leading to full densification at a temperature as low as 930 °C. However, the further addition of MnO2 hindered the densific...
متن کاملLOW-TEMPERATURE SINTERING AND MICROWAVE DIELECTRIC PROPERTIES OF (Zn0.65Mg0.35)TiO3-CaTiO3 CERAMICS WITH H3BO3 ADDITION
Low-melting H3BO3, acting as sintering aid, was used to reduce the sintering temperature of 5 wt.% CaTiO3-doped (Zn0.65Mg0.35)TiO3 ceramics. The sintering behaviors, microstructures and microwave dielectric properties with different amounts of H3BO3 addition were investigated. The results showed that H3BO3 additive was very effective for lowering the sintering temperature and improving the bulk...
متن کاملEffect of Sintering Temperature on Structural, Dielectric, and Magnetic Properties of Multiferroic YFeO3 Ceramics Fabricated by Spark Plasma Sintering
Based on precursor powders with a size of 200-300 nm prepared by the low-temperature solid reaction method, phase-pure YFeO₃ ceramics are fabricated using spark plasma sintering (SPS) at different temperatures. X-ray diffraction (XRD) and scanning electron microscopy (SEM) reveal that the high-purity YFeO₃ ceramics can be prepared using SPS, while the results from X-ray photoelectron spectrosco...
متن کاملLow Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملThe effect of sintering parameters on the microstructure and dielectric properties of bismuth titanate
In the present work, the effect of sintering parameters including sintering temperature, soaking time, and heating rate on densification, microstructure, and dielectrical properties of bismuth titanate (Bi4Ti3O12) ceramics were investigated. Bismuth titanate was synthesized by the solid state method and titanium oxide and bismuth oxide used as raw materials. X-ray diffraction (XRD) indicated, p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Institute of Electrical and Electronic Material Engineers
سال: 2008
ISSN: 1226-7945
DOI: 10.4313/jkem.2008.21.10.906