Planar LTCC Transformers for High-Voltage Flyback Converters
نویسندگان
چکیده
منابع مشابه
Analysis of High Frequency Planar Sandwich Transformers for Switching Converters
This paper presents the results of investigations on a planar sandwich air-gapped transformer with two different winding configurations. Experimental results of the coil self inductances, voltage ratio versus frequency, and the numerical results for the magnetic flux and eddy-current distributions are presented. It is shown that the voltage ratio and turns ratio are not equivalent and that the ...
متن کاملAlternating Voltage Tests on Distribution Transformers Using Static Frequency Converters
This paper presents experience in performing alternating voltage measurements on distribution transformers using a static frequency converter without particular control scheme. Regarding induced voltage tests, no-load and load measurements, the quality, i.e. the degree of distortion and the symmetrical shape, of the generated test voltage, deviations in measured power and the relation between d...
متن کاملCalibration of Voltage Transformers and High- Voltage Capacitors at NIST
The National Institute of Standards and Technology (NIST) calibration service for voltage transformers and high-voltage capacitors is described. The service for voltage transformers provides measurements of ratio correction factors and phase angles at primary voltages up to 170 kV and secondary voltages as low as 10 V at 60 Hz. Calibrations at frequencies from 50-400 Hz are available over a mor...
متن کاملAverage simulations of FLYBACK converters with SPICE3
Within the wide family of Switch Mode Power Supplies (SMPS), the Flyback converter represents the preferred structure for use in small and medium power applications such as wall adapters, off-line battery chargers, fax machines, etc. The calculations involved in the design of a Flyback converter, especially one which operates in discontinuous mode, are not overly complex. However, the analysis ...
متن کاملHigh frequency winding design for planar switch mode transformers
Switch mode power supplies as a mass produced article leave room for optimization especially at the voluminous magnetic components. Hereby planar component designs can reduce the overall height of the power supply and give it a more compact design. Since cores are available in standard sizes the optimal winding layout has to be found. Due to increased parasitic capacitance interleaving is not a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Components and Packaging Technologies
سال: 2010
ISSN: 1521-3331,1557-9972
DOI: 10.1109/tcapt.2009.2031872