Plane-strain compression of aluminum crystals

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Strain hardening behavior of aluminum alloyed Hadfield steel single crystals

Very high strain hardening coefficients (=G/23) are observed for aluminum-alloyed face-centered cubic Hadfield steel single crystals under tensile loading. Alloying with aluminum suppressed deformation twinning in two of the three crystallographic orientations studied, and transmission electron microscopy results revealed the existence of dense dislocation walls (sheets) along crystallographic ...

متن کامل

Bending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition

The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...

متن کامل

Bending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition

The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...

متن کامل

Data Compression of Cutting Plane

We propose an efficient algorithm for compressing cutting plane of three dimensional Computational Fluid Dynamics (CFD) data set. Observing the cutting planes of large 3D CFD data set is an important method for examination of simulation result, and efficient compression algorithm of these cutting planes is important for good performance of visualization when the simulation is running in a remot...

متن کامل

Measurement and prediction of deformation in plane strain compression tests of AA5182

The present paper concerns the numerical prediction and experimental measurement of the distribution of strain in a plane strain compression test by means of a gridded insert. The insert was engraved with a 161 mm grid pitch and was embedded in an AA5182 sample. The tests were performed at 400uC with a reduction ratio of y20% and at a strain rate of 0.7 s. A thermocouple was used to record the ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Acta Metallurgica

سال: 1966

ISSN: 0001-6160

DOI: 10.1016/0001-6160(66)90196-9