Plastic deformation and damage induced by fatigue in TWIP steels
نویسندگان
چکیده
منابع مشابه
Plastic strain due to twinning in austenitic TWIP steels
Twinning induced plasticity steels are austenitic alloys in which mechanical twinning is a prominent deformation mode, and which exhibit exceptional combinations of ductility, work hardening and ultimate strength. The authors develop in the present paper a crystallographic theory to enable the quantitative investigation of the role of mechanical twinning in enhancing the properties of these all...
متن کاملPlastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation
In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...
متن کاملComplementary use of TEM and APT for the investigation of steels nanostructured by severe plastic deformation
The properties of bulk nanostructured materials are often controlled by atomic scale features like segregation along defects or composition gradients. Here we discuss about the complimentary use of TEM and APT to obtain a full description of nanostructures. The advantages and limitations of both techniques are highlighted on the basis of experimental data collected in severely deformed steels w...
متن کاملStacking Fault Energy and Microstructural Insight into the Dynamic Deformation of High-Manganese TRIP and TWIP Steels
The dynamic behavior of three high manganese steels with very different stacking faultenergy (SFE) values (4-30 mJ/m2) were studied using high strain rate torsional tests. The hotrolledmicrostructure of the steel with the lowest SFE of 4 mJ/m2 consisted of a duplex mixture ofaustenite and ε-martensite, but those of the other two steels were fully austenitic. The deformedmicrostructures were stu...
متن کاملDamage Behavior in Modern Automotive High Strength Dual Phase Steels During Uniaxial Tensile Deformation
In the present research, damage mechanisms during room temperature uniaxial tensile testing of two different modern high strength dual phase steels,DP780 and DP980, were studied. Detailed microstructural characterization of the strained and sectioned samples was performed by scanning electron microscopy (SEM). The results revealed that interface decohesion, especially at the triple junctions of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Engineering: A
سال: 2015
ISSN: 0921-5093
DOI: 10.1016/j.msea.2015.01.043