Plastic deformation of Mild Steel Bar due to combined Tension and Torsion
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملOptimal plastic design of a bar under combined torsion, bending and shear
Optimal plastic design of a bar or beam under torsion with superposed bending and shear is obtained via the boundary perturbation method. Effects of bending and shear are expressed by a small parameter α. The results of optimization of solid bars and of hollow bars are shown.
متن کاملModelling, Simulation and Validation of Plastic Zone Size during Deformation of Mild Steel
Abstract—A model to predict the plastic zone size for material under plane stress condition has been developed and verified experimentally. The developed model is a function of crack size, crack angle and material property (dislocation density). Simulation and validation results show that the model developed show good agreement with experimental results. Samples of low carbon steel (0.035%C) wi...
متن کاملCombined Plastic Bending and Compression or Tension
So far we have assumed that a plastic hinge forms if the bending moment in a critical cross section reaches the plastic limit value, M0. We have tacitly neglected the effect of the other internal forces on the formation of the yield hinge. This effect, however, can be appreciable, for example in multi-storey frames or frames with a large horizontal thrust where the axial forces are large. So, w...
متن کاملCombined effect of rapid nitriding and plastic deformation on the surface strength, toughness and wear resistance of steel 38CrMoAlA
The combined treatment of pressurized gas nitriding and cold rolling is proposed as a new approach to rapid preparation of a strong and tough nitrided layer for steel 38CrMoAlA. The microstructural characteristics and properties of the modified surface layer in comparison with those of the conventionally gas nitrided sample have systematically been evaluated. The results show that the hardness ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1940
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.6.7