Plastic Design in Steel Structure (9 th report)
نویسندگان
چکیده
منابع مشابه
Plastic Analysis and Design of Steel Plate Shear Walls
A revised procedure for the design of steel plate shear walls is proposed. In this procedure the thickness of the infill plate is found using equations that are derived from the plastic analysis of the strip model, which is an accepted model for the representation of steel plate shear walls. Comparisons of experimentally obtained ultimate strengths of steel plate shear walls and those predicted...
متن کاملPerformance-Based Plastic Design of Moment Frame-Steel Plate Shear Wall as a Dual System
Steel Plate Shear Wall (SPSW) is an emerging seismic load-resistant system that, compared to other systems, enjoys the advantages of stable ductile behavior, fewer detailing requirements, rapid constructability, and economy. American seismic provisions decree that a SPSW should be designed as a moment frame with a web infill plate. Specifically, in case of buildings taller than 160 ft, it decre...
متن کاملStructural design of a roof steel structure having double curvature
Having as a starting point the idea of creating a structure with an iconic design, the current article presents all the technical solutions and steps followed in the process of creating this special structure. The structure, having the destination of a showroom for an auto dealer, is presented with an unconventional design of the roof: a roof structure having a double curvature. Starting from a...
متن کاملPlastic Design and Testing of Light-gauge Steel Plate Shear Walls
In this paper, the strip model developed by others and implemented in a Canadian Standard to model steel plate shear walls (SPSW) is used to develop, investigate, and quantify, through plastic analysis, the various possible collapse mechanisms of SPSW. Comparisons of experimentally obtained ultimate strengths of steel plate shear walls and those predicted by plastic analysis are given and reaso...
متن کاملPlastic Analysis and Design of Steel Plate Shear Walls (2001-2002)
A revised procedure for the design of steel plate shear walls is proposed. In this procedure, the thickness of the infill plate is found using equations that are derived from plastic analysis of the strip model, which is widely accepted for the representation of steel plate shear walls. Equations are derived from a basic steel plate shear wall configuration but are shown to be conservative for ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Naval Architects of Japan
سال: 1968
ISSN: 1884-2070,0514-8499
DOI: 10.2534/jjasnaoe1968.1968.124_171