Pneumatic Vehicle, Research and Design

Pneumatic Conveying Design Guide

Design of Pneumatic Diffuser System

During non-generation periods, leakage through the wicket gates of a hydroturbine often results in very poor quality water (low or zero dissolved oxygen) in the tailrace of the hydropower facility. Generally, the leakage rate is relatively small, usually about 5-10 cfs per turbine. A bottom-mounted diffuser system was designed based on laboratory-measured and manufacturer-supplied specification...

Design and Fabrication of Pneumatic Robotic Arm

This project aims to Design and fabricate pneumatic arm for pick and place of cylindrical objects. The handling of materials and mechanisms to pick and place of objects from lower plane to higher plane and are widely found in factories and industrial manufacturing. There are number of pneumatic arms are available which consists of so many mechanisms hence becomes expensive. The designed pneumat...

Design and Experimental Study of a Combined Pneumatic Plot Seed-metering Device for Cotton

This study presents a combined pneumatic seed-metering device (SMD) that could not only fill, carry, and meter seeds, but also switch quickly between seed-metering and seed-cleaning modes, and clean seeds thoroughly and rapidly. The seed-filling, seed-carrying, and seed-metering modes of the SMD were analyzed based on a theoretical kinematic model. Furthermore, a three-factor, three-level ortho...

Electrical Vehicle Design and Modeling

Electric vehicles are by many seen as the cars of the future as they are high efficient, produces no local pollution, are silent, and can be used for power regulation by the grid operator. However, electric vehicles still have critical issues which need to be solved. The three main challenges are limited driving range, long charging time, and high cost. The three main challenges are all related...