Polymorphism of a semi‐crystalline diketopyrrolopyrrole‐terthiophene polymer
نویسندگان
چکیده
منابع مشابه
Simulation of Multifilament Semicrystalline Polymer Fiber Melt-Spinning
The goal of this effort is to provide an accurate simulation of multifilament fiber melt spinning, applicable for a wide range of material and process conditions. For ease of use, the model should run on a standard laptop or desktop computer in reasonable time (one hour or less). Most melt spinning models simulate the formation of a single filament, with little or no attention given to multifil...
متن کاملComparative surface dynamics of amorphous and semicrystalline polymer films.
The surface dynamics of amorphous and semicrystalline polymer films have been measured using helium atom scattering. Time-of-flight data were collected to resolve the elastic and inelastic scattering components in the diffuse scattering of neutral helium atoms from the surface of a thin poly(ethylene terephthalate) film. Debye-Waller attenuation was observed for both the amorphous and semicryst...
متن کاملSelf-assembling semicrystalline polymer into highly ordered, microscopic concentric rings by evaporation.
A drop of semicrystalline polymer, poly(ethylene oxide) (PEO), solution was placed in a restricted geometry consisting of a sphere on a flat substrate (i.e., sphere-on-flat geometry). Upon solvent evaporation from the sphere-on-flat geometry, microscopic concentric rings of PEO with appropriate high molecular weight were produced via controlled, repetitive pinning ("stick") and depinning ("slip...
متن کاملSorption of Gases in Semicrystalline Polyethylene
Polyethylene is the most popular man-made polymer. One way of making polyethylene consists in producing the polymer in the form of grains suspended by a gas flow of olefins (monomers), nitrogen and other hydrocarbons (alkanes). Industrials want to know the solubility of the monomers in the polyethylene grains, as the rate of the polymerization reaction is a direct function of this solubility. T...
متن کاملElectromechanical instability in semicrystalline polymers
When a layer of a semicrystalline polymer is subject to a tensile force in its plane and a voltage through its thickness, the deformation of the layer is initially homogeneous, but it then localizes. The electromechanical instability sets in when the force and the voltage reach critical conditions. The critical conditions are determined in this paper and are related to the following two special...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Polymer Science
سال: 2020
ISSN: 2642-4150,2642-4169
DOI: 10.1002/pol.20200673