Polyurethane elastomer as a matrix material for short carbon fiber reinforced thermoplastic composites
نویسندگان
چکیده
منابع مشابه
Properties of agave fiber reinforced thermoplastic composites
Biocomposites have attracted a great deal of interest in research and industry sectors because they are typically lightweight, sustainable, environmentally friendly, and their thermomechanical properties can be designed to fit specific applications by tuning of their composition. In this study, mechanical properties of natural-fiber reinforced thermoplastic composite films were explored. Thermo...
متن کاملOverview of Flax Fiber Reinforced Thermoplastic Composites
Flax fibres are oftenly used for reinforcing thermoplastic to manufacture biocomposite materials exhibiting numerous advantages such as high mechanical properties, low density and biodegradability. The mechanical properties of a biocomposite material depends on the nature and orientation of the fibres, the nature of the matrix and mainly on the adhesion between fiber and the polymer matrix. The...
متن کاملMechanical Properties of Nonwoven Reinforced Thermoplastic Polyurethane Composites
Reinforcement of flexible fibre reinforced plastic (FRP) composites with standard textile fibres is a potential low cost solution to less critical loading applications. The mechanical behaviour of FRPs based on mechanically bonded nonwoven preforms composed of either low or high modulus fibres in a thermoplastic polyurethane (TPU) matrix were compared following compression moulding. Nonwoven pr...
متن کاملCarbon Fiber Reinforced Bismaleimide Composites
Bismaleimide (BMI) resins are developed very rapidly due to the demands of the defense and aerospace industries. They are cross-linked polymers which process like epoxy resins but have an upper use temperature of 230°C, compared to the epoxy upper use temperature of 175°C. Also due to the available intrinsic properties of BMI resins such as higher thermal stability and lower toxicity than those...
متن کاملFiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ANADOLU UNIVERSITY JOURNAL OF SCIENCE AND TECHNOLOGY A - Applied Sciences and Engineering
سال: 2017
ISSN: 1302-3160
DOI: 10.18038/aubtda.271011