POWER RECYCLE USING POSITIVE FEEDBACK ADIABATIC SYSTEM
نویسندگان
چکیده
منابع مشابه
Feedback-controlled adiabatic quantum computation
We propose a simple feedback-control scheme for adiabatic quantum computation with superconducting flux qubits. The proposed method makes use of existing on-chip hardware to monitor the ground-state curvature, which is then used to control the computation speed to maximize the success probability. We show that this scheme can provide a polynomial speed-up in performance and that it is possible ...
متن کاملSPIO: Positive contrast by adiabatic IRON using repetitve inversion pulses
Introduction Superparamagnetic iron oxide particles (SPIO) have been shown to accumulate in lymph nodes and macrophages, e.g. within atherosclerotic plaque. [1-2] Susceptibility weighted imaging is the most sensitive means to detect the particles, however the lack of signal caused by the magnetic dipole field perturbations is ambiguous, as numerous other sources of signal loss exist. To overcom...
متن کاملLaser Soldering of Rat Skin Using a Controlled Feedback System
Introduction: Laser tissue soldering using albumin and indocyanine green dye (ICG) is an effective technique utilized in various surgical procedures. The purpose of this study was to perform laser soldering of rat skin under a feedback control system and compare the results with those obtained using standard sutures. Material and Methods: Skin incisions were made over eight rats’ dorsa, which w...
متن کاملDesign of Low Power 4-bit ALU Using Adiabatic Logic
This paper presents the implementation of a 4-bit Arithmetic Logic Unit (ALU) using Complementary Energy Path Adiabatic Logic (CEPAL). This static adiabatic logic has proved its advantage through the minimization of the 1/2CVdd2 energy dissipation occurring every cycle. Firstly, the performance characteristics of CEPAL 4-to-1 multiplexer and full adder are compared against the conventional stat...
متن کاملDesign and Power Analysis of Sequential Circuits using Adiabatic Technique
One of the biggest challenges of our times is to limit the power consumed in electronic devices which will lead to longer battery life while maintaining high performance. Several different design methodologies are being probes with this end in mind. In this paper conventional CMOS and adiabatic reduction technique for D, T, SR and JK is compared and their static and average power is computed. A...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering Applied Sciences and Technology
سال: 2020
ISSN: 2455-2143
DOI: 10.33564/ijeast.2020.v04i12.055