Precision Temperature Measurement Using CMOS Substrate PNP Transistors
نویسندگان
چکیده
منابع مشابه
Substrate Noise Reduction in CMOS Transistors: a methodology definition
Substrate coupling can corrupt low level analog signals and impair the performance of monolithic integrated circuits. Therefore, a characterization methodology able to evaluate the efficiency of the countermeasures against crosstalk, appears very important for designers. In this paper, after the verification that PMOS transistors are more sensitive to substrate voltage fluctuations than NMOS on...
متن کاملDesign of a Noise Measurement System for CMOS Transistors
One of the fundamental limitations on all analog electronics circuits is the noise generated by the individual transistors. This project is a design of a system to allow laboratory measurements of the noise output by MOSFET transistors, of either N-channel or P-channel devices. The system currently extends frequency response to roughly 10 MHz with the possibility of a higher bandwidth amplifier...
متن کاملDifferential Precision Rectifier using Single CMOS DVCC
Three novel differential precision rectifier circuits are realized using single CMOS differential voltage current conveyor. One of the realized differential precision rectifiers provides half wave voltage output. The other two circuits give full wave voltage outputs. Among the two full wave differential precision rectifiers, one circuit provides single ended voltage output while other full wave...
متن کاملBiasing CMOS amplifiers using MOS transistors in subthreshold region
The implementation of large-valued floating resistive elements using MOS transistors in subthreshold region is addressed. The application of these elements to bias wideband AC coupled amplifiers is discussed. Simple schemes to generate the gate control voltages for the MOS transistors implementing large resistors so that they remain in high resistive state with large signal variations are discu...
متن کاملA Low-Voltage Current-Mode Wheatstone Bridge using CMOS Transistors
This paper presents a new circuit arrangement for a current-mode Wheatstone bridge that is suitable for low-voltage integrated circuits implementation. Compared to the other proposed circuits, this circuit features severe reduction of the elements number, low supply voltage (1V) and low power consumption (<350uW). In addition, the circuit has favorable nonlinearity error (<0.35%), operate with ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Sensors Journal
سال: 2004
ISSN: 1530-437X
DOI: 10.1109/jsen.2004.826742