Predicting microstructure and strength of maraging steels: Elemental optimisation
نویسندگان
چکیده
منابع مشابه
Microstructure and cleavage in lath martensitic steels
In this paper we discuss the microstructure of lath martensitic steels and the mechanisms by which it controls cleavage fracture. The specific experimental example is a 9Ni (9 wt% Ni) steel annealed to have a large prior austenite grain size, then examined and tested in the as-quenched condition to produce a relatively coarse lath martensite. The microstructure is shown to approximate the recen...
متن کاملHigh-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
متن کاملModelling the correlation between processing parameters and properties of maraging steels using artificial neural network
An artificial neural network (ANN) model is developed for the analysis and simulation of the correlation between the properties of maraging steels and composition, processing and working conditions. The input parameters of the model consist of alloy composition, processing parameters (including cold deformation degree, ageing temperature, and ageing time), and working temperature. The outputs o...
متن کاملModelling the Microstructure of Martensitic Steels
A method based on the kinetics of crystal growth has been developed and applied to the computation of three-dimensional microstrucuture in austenite-matensite steels. The detailed crystallography of the transformation is used to model a realistic martensitic microstrucuture during the transformation without an external system of stresses. The interaction energy based on the plastic work model i...
متن کاملInfluence of Machining Parameters on Electric Discharge Machining of Maraging Steels – An Experimental Investigation
thermoelectric process in which heat energy of spark is used to remove material from the work piece. The machining process involves controlled erosion of electrically conducting material by the initiation of rapid and repetitive electrical spark discharges between the tool and workpiece separated by the dielectric medium. The present work is aimed at characterizing the electric discharge machin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2016
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2016.07.020