PREDICTING THE STRUCTURAL PERFORMANCE OF SANDWICH CONCRETE PANELS SUBJECTED TO BLAST LOAD CONSIDERING DYNAMIC INCREASE FACTOR

Simulation of the Reactive Powder Concrete (RPC) Behavior Reinforcing with Resistant Fiber Subjected to Blast Load

In research or experimental works related to blast loads, the amount of explosion material and distance of explosion point are very important. So, in this paper has been attempted to present a parametric study of the reactive powder concrete subjected to blast load. The effect of the different amount of TNT adopted the literature, distance of explosion point from RPC slab and also the location ...

Performance of Polymer-encased Concrete Walls Subjected to Blast Loads

Composite Behavior of Insulated Concrete Sandwich Wall Panels Subjected to Wind Pressure and Suction

A full-scale experimental test was conducted to analyze the composite behavior of insulated concrete sandwich wall panels (ICSWPs) subjected to wind pressure and suction. The experimental program was composed of three groups of ICSWP specimens, each with a different type of insulation and number of glass-fiber-reinforced polymer (GFRP) shear grids. The degree of composite action of each specime...

Optimization of Composite Sandwich Cover Panels Subjected to Compressive Loadings

An analysis and design method is presented for the design of composite sandwich cover panels that includes transverse shear e ects and damage tolerance considerations. This method is incorporated into a sandwich optimization computer program entitled SANDOP. As a demonstration of its capabilities, SANDOP is used in the present study to design optimized composite sandwich cover panels for transp...

Structural Response of Polyethylene Foam-Based Sandwich Panels Subjected to Edgewise Compression

This study analyzes the mechanical behavior of low density polyethylene foam core sandwich panels subjected to edgewise compression. In order to monitor panel response to buckling, strains generated in the facesheets and overall out-of-plane deformations are measured with strain gages and projection moiré, respectively. A finite element (FE) model simulating the experimental test is developed. ...