Prediction of fracture toughness temperature dependance from tensile test parameters
نویسندگان
چکیده
منابع مشابه
Prediction of Mode II of Fracture Toughness in Laminate Composites
In this paper, effects of ply orientation of adjacent plies with (ϕ//θ) interfaces on mode II critical strain energy release rate (fracture toughness) of multidirectional (MD) laminate has been studied. Ply orientation of adjacent plies is one of the most important parameters affects the mode II critical strain energy release rate () in the initiation of the delamination. To study this paramet...
متن کاملFracture toughness of dental composites determined using the short-rod fracture toughness test.
Plane strain fracture toughness (KIC) has been evaluated for a number of commercially-available dental composites. A modified Short-rod Fracture Toughness (SRFT) specimen design has been used, enabling small specimens to be tested conveniently. The effect on KIC of aging in water at 37 degrees C for seven days, one month, and six months has been determined for conventional, microfilled, and hyb...
متن کاملReduced Fracture Toughness of Metallic Glass at Cryogenic Temperature
The effects of cryogenic temperature on the toughness of a Zr-based metallic glass are investigated. Based on three-dimensional fracture morphologies at different temperatures, the crack formation and propagation are analyzed. Through the calculation of the shear transformation zone volume, the shear modulus and bulk modulus of the metallic glass at different temperatures and the crack formatio...
متن کاملBehavior of Concrete round Double Beam Fracture Toughness Test Specimens
Laboratory fracture toughness tests of concrete using wedge-loaded round double beam specimens with a length to diameter ratio of 2:1 show two distinctly different specimen behaviors. Either the crack remains in the plane of the notch, and a valid test result can be obtained, or there is lateral cracking around mid-length which invalidates the results. Results of a controlled study show that th...
متن کاملFracture Toughness of Advanced Ceramics at Room Temperature
This report presents the results obtained by the five U.S. participating laboratories in the Versailles Advanced Materials and Standards (VAMAS) round-robin for fracture toughness of advanced ceramics. Three test methods were used: indentation fracture, indentation strength, and single-edge pre-cracked beam. Two materials were tested: a gas-pressure sintered silicon nitride and a zirconia tough...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallic Materials
سال: 2010
ISSN: 0023-432X
DOI: 10.4149/km_2010_6_345