Preheat conditions of Fillet Weld for steel bridge fabrication
نویسندگان
چکیده
منابع مشابه
Welding Gun Inclination Detection and Curved Fillet Weld Joint Tracking
It is important to adjust the welding gun's inclination during automatic curved-joint tracking of arc welding. In this paper, a novel method is proposed to detect the deviation and inclination of the welding gun based on the arc currents acquired by a high-speed rotational arc sensor. It uses a least-squares method to fit the arc currents to a plane in three dimensions. The deviation and inclin...
متن کاملTransformation Plasticity in Steel Weld Metals
Professor Ulrich Dilthey’s passion for the science and technology of joining processes is amply reflected in the enormous archive of published work which will forever serve the community. It is a pleasure therefore to be able to present this small story as a tribute to someone who has been a scholar, a gentleman and a leader in this most difficult of subjects. The matter of our everyday world i...
متن کاملEffects of weld preheat temperature and heat input on type IV failure
Type IV cracking refers to the premature failure of a welded joint due to an enhanced rate of creep void formation in the fine grained or intercritically annealed heat affected zone. A great deal of research effort has been directed at understanding the underlying mechanisms for this type of failure, but most have approached the problem from a metallurgical standpoint, and comparatively little ...
متن کاملMicrostructural characterisation of as-deposited and reheated weld metal — High Strength Steel Weld Metals
The problems encountered with the interpretation of martensite and the various forms of bainite that are found in high strength steel weld metals have been addressed. Field emission gun scanning electron microscopy was found to overcome resolution difficulties often met with light optical microscopy and conventional scanning electron microscopy. The various microstructural constituents were cha...
متن کاملSize distribution of oxides and toughness of steel weld metals
The trend in strong weld metals is towards microstructures dominated by low carbon martensite. The role of oxide particles introduced into the metal during welding then becomes uncertain. The particles do not seem to affect the nucleation or growth of martensite. This is probably because this phase forms at relatively large driving forces and therefore does not rely on heterogeneous nucleation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 2007
ISSN: 0288-4771
DOI: 10.2207/qjjws.25.10